Top-rated water heater pros.

Best water heater pros near Murray, NE

Enter your zip and get matched with up to 5 pros

Need a pro for your water heater service project in Murray, NE?

Select your specific project to find the pro for you.

Top-Rated Water heater pros in Murray - Updated Nov 2026

Avatar for Plumbing Specialties
Plumbing Specialties
4.2(
97
)
Water Heater - Install or ReplaceWater Heater - Install or Replace - For Business

Serving Murray, NE and surrounding areas

In business since 2009

Free estimates

Warranties offered

"Job was performed very well, the two water heater installers and phone representative were friendly, the installers showed up right on time, the job time estimate was 2 hours, the installers did it in 1.5 hours, they even did a good job of cleaning up afterwards, couldn't of asked for a better job, excellent"
Response time2 hrs
Recommended by95%of homeowners
Showing 1-10 of 21
Water Heaters FAQs, answered by experts

Yes, this would be an appropriate choice. In order to comply with the National Electric Code’s rules, you'll need to install a circuit breaker that's 125% larger than the intended load. In this case, you'll multiply 30 amps by 1.25 to find the necessary breaker size. Plugging that equation in for your 30-amp water heater will leave you with a 37.6-amp breaker. If your current water heater keeps tripping the breaker, it might be time to talk to a plumber or electrician about upgrading your water heater's setup.

Flushing biannually, checking the anode rod, and temperature settings maximize equipment lifespan while reducing surprise costs.

While heat pump water heaters are more expensive than gas-powered water heaters, the ROI is higher for heat pump units. Not only are heat pump water heaters more energy efficient, meaning immediate savings on your energy bill, but they also last longer than traditional gas versions, meaning you won't have to buy them as often.

Due to the high temperature, using stainless steel vent pipes for your tankless water heater’s exhaust vent is best. Also, it is safe to use a flexible vent duct as the exhaust fan. If installing the exhaust fan yourself, make sure you are using heat-resistant silicon to connect the exhaust vent and the duct on your water heater.

The average cost to install a new water heater is approximately $1,300, with a typical price range between $880 and $1,800. The final cost depends on several factors, including the type and size of the unit, its location and accessibility, and the amount of labor required. For example, installing a unit in a tight space like a crawl space can increase labor costs. The type of water heater significantly impacts the price: while a conventional gas heater might cost less than $1,000, tankless models can cost around $2,600 to install (and up to $3,500), and solar heaters can cost upwards of $3,700. Other factors that can affect the total price include the fuel type, vent system requirements, permits, and whether any additional plumbing work or repairs from previous water heater damage are needed.

The Murray, NE homeowners’ guide to water heater services

From average costs to expert advice, get all the answers you need to get your job done.