Get matched with top marble restoration pros in Saint Michael, ND

Engineered stone is known for its durability, lasting 15 to 20 years or longer. Of course, this range assumes high-quality materials and regular maintenance. After a couple of decades, the stone will start showing its age. Watch for discoloration, fading, stains, and burns, but it’s unlikely that engineered stone will experience structural failure.

Silestone® is heat-resistant, so it can handle moderately high temperatures for a short period of time. That said, exposure to high heat can cause serious damage. You should never take a hot pan off the stove and place it directly on your countertop. Temperatures above 300 degrees Fahrenheit can leave marks or discoloration on the surface. Instead, use a trivet.

The frequency for sealing granite countertops depends on several factors, including the type of sealant used, the color of the granite, and how heavily the countertops are used. As a general guideline, resealing is often recommended every 12 to 18 months, but some sources suggest it could be as often as every few months or at least once a year.

The type of sealant is a major factor: water-based sealants may need reapplication every six months to a year, while more durable solvent-based sealants can last for five to 10 years. Additionally, factors like heavy kitchen traffic, frequent use of acidic cleaners, and lighter granite colors may require more frequent sealing to prevent staining.

To determine if your countertops need resealing, you can perform a simple water test. Place a few drops of water or a wet paper towel on an inconspicuous area of the granite. After 10 to 15 minutes, check the spot. If the water has beaded up, the seal is still intact. If the water has been absorbed and darkened the stone, it's time to apply a new coat of sealant. You can choose to seal the granite yourself or hire a professional to ensure it's done correctly.

You can cut granite countertops after installing them, but you need to consider the mess it will make. Dust will be everywhere, and lots of protective gear will be required. On top of that, you will need to measure meticulously to make sure the cuts you make are perfect; otherwise, you’ll be stuck having to replace the entire slab of granite, which is a much bigger job.