Get matched with top marble restoration pros in Cavalier, ND

Clorox wipes contain bleach, which is unsafe for use on quartz countertops. When used over time, the bleach will damage the countertop surface and cause it to become discolored or damaged. Instead of Clorox wipes, use a pH-neutral multipurpose solution and clean the surface gently using a soft microfiber cloth.

Unsealed granite is more susceptible to staining and other damage. Regularly sealing your granite countertops decreases the chances you’ll need to repair damaged countertops in the future. It also keeps it looking shiny rather than becoming dull over time. You can check whether your granite needs resealing by putting a few drops of water on the counter and waiting 15 minutes to see whether the water permeates the surface.

Extensive chips and cracks may require a full replacement of the countertop. The cost to install a new countertop is around $3,100 on average. But, if the damaged area is relatively small, you may want to consider repairing it yourself or calling in a qualified professional. Depending on the material, some epoxy and sandpaper may do the trick. Or you can consider painting laminate countertops or refinishing butcher block countertops.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.