Get matched with top septic tank pros in Dunseith, ND

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.

The lifespan of your well casing depends mainly on the material it’s made from. Stainless steel and galvanized steel casings are designed to withstand the pressures and environment of deep-water wells but are susceptible to corrosion. Most steel casings last from 20 to 35 years, on average. PVC casing is highly durable and, if used correctly, can last up to 50 years.

The average three to four-bedroom home typically uses a well pump rated for 8 to 12 gallons per minute (GPM). To find the most accurate size for your specific needs, a common rule of thumb is to count the number of water fixtures and appliances in your home and aim for that number in GPM. This calculation allows for about one gallon of water per minute per fixture. Because estimating the correct size can be challenging, it's best to have a professional technician make the final determination. A professional can ensure your pump provides sufficient water for your home, especially during peak usage hours.

Septic tanks naturally have bacteria that break down some of the solid waste in the septic tank. However, sludge buildup is just part of owning a septic system. While liquid wastewater can be filtered and treated through the system, a septic tank company has to pump the septic tank out at least every few years.