Question 1

Does basement insulation need a vapor barrier?

Accepted Answer

•

Yes, basement insulation needs a vapor barrier due to its susceptibility to moisture seeping in from the outside of the house. You should install a moisture barrier before you install insulation or purchase insulation that comes prebuilt with a moisture barrier to avoid water damage in your insulation and costly mold and water remediation expenses.

Question 2

How much does a radiant barrier cost?

Accepted Answer

•

The cost to install a radiant barrier ranges from $700 to $2,800, depending on the size of your roof and the type you choose. Most people pay an average of $1,700 to install a radiant barrier. Foil options, both single- and double-sided, cost between $0.10 and $0.90 per square foot, while spray-on options start at $0.60 and go all the way up to $1 per square foot—which can add up quickly.

Question 3

Is doubling up insulation a good idea?

Accepted Answer

•

Doubling the insulation in your home also doubles the R-value of said insulation. In other words, by adding more insulation, you can reduce the heat loss by half. Most homes benefit from increasing insulation. Older homes, in particular tend to have less insulation as is, so doubling your insulation could drastically reduce your energy bills, keep your home more comfortable, and take the strain off your HVAC system.

Question 4

Do you need to insulate your basement?

Accepted Answer

•

Depending on where you live and the conditions of your basement, you may not need to insulate your basement. Your best bet is to talk to a basement remodeling company to find out what they recommend doing.

Insulating your basement can help improve your home's energy efficiency, but it will also increase the cost of your basement remodel project. The average cost of installing basement insulation is $2,400.

Question 5

What is the most affordable way to insulate behind drywall?

Accepted Answer

•

The most affordable way to insulate behind unfinished walls is to install fiberglass batts or rolls. These total around $0.75 per linear foot, with the width matching the gaps between standard studs perfectly. However, it’s important to consider the R-value of your insulation and the climate in your area, as fiberglass insulation isn’t the best in terms of preventing heat transfer. Plus, the most affordable option may cost more on electricity bills over time. The most affordable way to insulate behind finished walls is to leave them up and use blown-in insulation to avoid drywall replacement.