Get matched with top roofers in Newland, NC

It’s possible to install your chimney cap in some areas, but it’s usually better to hire a professional. Before you attempt a DIY chimney cap installation, check to see if your local building department requires a permit. If it does, you should hire a professional to pull the permit and complete the work for you. Even if you don’t need a permit, getting up on your roof is dangerous, especially if you have an aggressive pitch or slippery roof material, like metal. Hiring a chimney professional guarantees the job is done correctly and keeps you safe from injury.

There should be small gaps between your roof and the walls of your home, and other buildings. These small gaps let building materials shift, expand, and contract with weather and other outside forces, and they prevent moisture from wicking down walls from roofing and gutter systems. Without these strategic gaps, your home’s exterior and its finishes can sustain water damage, decay, peel, delaminate, and crack. However, there is a fine line between a smart gap and a problematic gap—all  gaps should be small, intentional, and covered or filled in with foam insulation to prevent pests from using them as access points.

A roof replacement can take anywhere from one to 14 days. For most homes, a full replacement that includes tearing off old materials takes about one to two days, though the average project can last up to 12 days. The exact timeline depends on several factors, including the roof's size and complexity, the type of roofing material, the crew size, and weather conditions. Certain materials take longer to install; for example, metal roofs can take seven to 14 days because the material is more difficult to work with than asphalt shingles, wood, or tile. A re-roofing project, where new shingles are installed over old ones, can take half the time or less. It's also important to factor in the time needed to obtain necessary permits. A professional roofing contractor will typically complete the job faster than a DIY approach.

Venting a gas water heater out of the roof is preferable in most cases. Heated exhaust gases naturally rise, so a vertical vent pipe is efficient. If you’re trying to vent through a pipe exiting a wall, the angle of the pipe may be more horizontal than vertical, making the venting system less effective. If you go through a wall, you may need to add a fan to ensure a successful expulsion of the gases outdoors.