Get matched with top toilet pros in Morganton, NC

A wax ring can often last the entire lifespan of a toilet, which is typically 20 to 30 years. However, it may need to be replaced sooner if it becomes damaged. Signs that your wax ring needs replacement include bad odors or leaks coming from the base of the toilet. The wax can also dry out, flake, or crumble if the toilet was not secured correctly upon installation or has become loose over time. If you notice your toilet wobbles, it's a good indication that the wax ring may be compromised and should be inspected to prevent leaks.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

The cost to install a new toilet typically runs from $225 to $530. This doesn’t include the price of the toilet itself, which can cost $90 to $1,500 depending on the model and features you choose. You can save money if you choose to install a toilet yourself. However, you might want to hire a pro for this project.

"Due to the many complexities of replacing a toilet flange, it is typically a job best left to the pros," says Jeff Botelho, Angi Expert Review Board member and plumber. "Many times it isn't as simple and straightforward as 'pop off the old one and pop on a new one' because the flange is either glued on (PVC/ABS), soldered on (brass/copper), or caulked in place with a lead & oakum joint (cast iron) and none of these things can be easily reversed without years of training and repetitive practice."

A gurgling toilet usually doesn’t mean that your septic tank is full. If waste can’t drain into a full septic tank, you’ll see water and sewage backing up into your fixtures, but the air that causes gurgling is a result of poor venting. You are more likely to have a clog in your vent stack or a damaged air admittance valve.