Get matched with top drywall insulation pros in Franklinton, NC

"I needed insulation put into existing walls without any remodel. They came and did blown in fiberglass from the exterior walls. They did a great job and were super friendly. Some issues came up during the job with my interior drywall because the sheetrock was installed incorrectly. They didn’t hesitate to come in and fix the problem. They cleaned up after themselves before leaving where you couldn’t even tell they were there. I noticed an immediate difference in sound and comfort in the house. I am very impressed with how friendly and professional they were. The job was quick and effective. Highly recommend."

"So happy I went with USA Insulation. After learning about foam insulation, I knew it was the right option for my house. They insulated my walls and attic in a day and a half, and I could feel the difference right away."

"Everything went according to plan. Crawlspace insulation was replaced and closed space was sealed up. A air inducer was also installed. The environment is totally different down there now and is much closer to the temperature of the house. I kept my vapor barrier the same."

"The door install looks great! I would recommend this company!"

"I was very happy with my insulation the men were super whoo hoo to antonio,Adrian and Jayson very nice young men and they did good work"

"Great service and very good communication with us,"

"Initial install into garage ceiling did not work. Subsequent parts and method did seem to work well to achieve a dense pack with fiberglass blown in. A lot of holes in the drywall ceiling. Be aware, a lot of dust from drywall during install and drywall repair. Price was very fair. Pleasant vendor. This was a complicated job."

"He came to the house upon my request.  He looked through the crawl openings, and measured the outside of the house.  He followed up with a phone call.  Well done"

"My family and I have been living in an RV for over a year now, due to hurricane Florence. It has been a nightmare dealing with shady, lazy and difficult tradesmen but doing business with Mitch has been the easiest thing in this whole process. I called him on a Friday to insulate my entire home and he was completely done by the following Tuesday, before lunch time. He s extremely friendly and an excellent communicator. He kept me in the loop the entire time and showed up when he said he was going to. He does quick work but he is very proficient and he actually cleaned up after himself, which seems to be completely unheard of. We called around to multiple businesses for spray insulation and Mitch is by far the BEST price you will find out there. He even gave me a really good discount because I think he s just a nice guy. I highly recommend Mitch. He will make your life easier in regards to upgrading your home."

"Our builder had never used spray foam, so once we decided to go spray foam, we got a great education from Rich Brown of Prime Energy group. He was wonderful to work with, and helped guide us on some very important issues including HVAC sizing. His company had all their paperwork ready for Orange County NC inspectors, and he was very flexible given all the delays we experienced before we were ready. When our spray day finally was approaching (4 months after the initial consultation), Rich came out again to go through the job again with us, answer any last minute questions, and make sure he did not see any concerns for going forward. Once we were ready, the company sent two crews. Rich went through the job with them and they finished it in one day! The crews even did a good job of keeping the mess to a minimum, despite the fact the trimmed foam bits are very much like styrofoam to manage. The inspection went off without a blink, and the job looks great! I really would recommend them as top notch, and priced fairly for the level of job they did for us. My only remark for those considering spray foam: make sure all outlets, vent pipes or air inlets are in their final place and fastened down before spray. You cannot easily reposition or push them into place afterword, and who wants to damage their new insulation? Thankfully, we thought of that for the outside vents because those would have been a nightmare to fix. On inside, we had two outlets that were screwed only from one side rather than nailed and the dryer vent 'hutch' that was not fastened that were pushed out by the foam which are going to be difficult to fix. My husband will also have to pull the sides of our shower pan liner and cut some foam back before that area is tiled since the flexible liner pushed in, but that should be simple. We used open cell foam and are very happy with the results, and there are no weird odors or fumes after a day's curing. Call Rich, he knowns his stuff."