Get matched with top floor polishers in Fair Bluff, NC

To properly maintain and care for hardwood floors without damaging the finish, establish a regular cleaning routine. Sweep with a broom or microfiber dust mop daily, or vacuum weekly, to remove dirt and debris that can scratch the surface; be sure to clean in tight corners and under furniture. For a deeper clean, use a damp mop with a cleaner specifically designed for hardwood floors, but avoid using harsh chemicals or excessive water, as this can damage the wood. You can further protect your floors by placing mats at entryways to catch dirt and moisture and putting felt pads under furniture legs to prevent scratches. For long-term care, refinish the floors as needed to keep them looking their best.

Using too much soap or floor cleaner can leave your laminate floors looking dirty or cloudy after mopping. Only use a teaspoon of soap or cleaning solution in a gallon of water. Additionally, always be sure to sweep or vacuum laminate floors before mopping to ensure you pick up dried grit, hair, and dust that can be harder to catch with a wet mop.

The best solution for mopping floors depends on the type of floor you have, but a good all-around or multi-purpose DIY floor cleaner is 2 cups of warm water, 5 to 10 drops of liquid dish soap, and 1 tablespoon of lemon juice. This is safe to use on tile, laminate, wood, polished concrete, vinyl, and more, as it’s relatively neutral and lacks caustic and abrasive chemicals that could be harmful to children and pets. You can also use a multi-purpose commercial cleaner, but make sure to follow the directions for safety.

Before installing shoe molding, evaluate redoing or refinishing any floors and painting your walls or baseboard before putting on your shoe molding. If you don’t already have baseboard trim, you should install that before adding shoe molding. Shoe molding is the final touch. Additionally, a carpenter or other professional that’s installing shoe molding might also give you a deal on installing crown molding and replacing other trim if you get them done at the same time.