Get matched with top doorbell installation pros in Dunn, NC

You do not always need to remove old insulation before adding new. If the existing insulation is in good condition—not wet, physically damaged, moldy, or infested with pests—you can add new insulation directly on top of it for a compounding effect. You can also mix different types, such as adding blown-in insulation around existing fiberglass batts.

However, removal is recommended if the old insulation is compromised by water damage or pests. You should also remove it if you plan to install a different type of insulation, like switching from roll or batt insulation to spray foam. If the existing insulation is very old or damaged, you will likely get more benefit from removing it and starting fresh.

Heat lost through uninsulated basement walls can account for up to 30% of the total energy lost through heat transfer to the outdoors. While homes in mild climates won't gain as much benefit from having an insulated basement as those in cold climates, the effects are still noticeable on your energy bill.

It is possible to install a radiant barrier yourself. However, knowing how to install a radiant barrier and actually doing it are two totally different things. For example, it’s important that they be installed in a straight line but at an angle that creates a gap between the roof panels and the foil or spray. If this gap is too large or small, it won’t function as it should, and that may be hard to avoid if you’re only a novice. When in doubt, leave this job to a pro.

In addition to adding insulation to your attic, you may want to add a radiant barrier. A radiant barrier works by using reflective material, such as foil, on the attic floor. As heat penetrates the roof and enters the attic, the radiant barrier reflects the heat upward and back through the roof. If you receive a lot of direct sunlight on the roof, using both a radiant barrier and insulation in your attic can provide significant benefits.