Get matched with top toilet pros in Superior, MT

Snaking a toilet is similar to clearing sinks and bathtubs, but there are unique circumstances where you’d have to drain, disassemble, and remove the toilet to fix the clog. For stubborn clogs in the toilet trap, a toilet auger—designed with a shorter cable and a protective plastic encasing—can navigate the tight bends and clear the clog without risking damage to the porcelain. 

The normal water level in a toilet bowl is about halfway full. The water should sit above the P trap drain because this creates a seal and suction. When you flush the toilet, the suction keeps sewer gases from entering your house through your toilet. Anytime the water level is higher or lower than half full, you need to make adjustments or replace broken parts.

The water in your toilet tank refills after each flush. So if you see dirty water in the bowl, you should check the tank to see if it’s coming from there. A dirty toilet tank can be the result of sediment in the water itself—-after all, the water will sit in the tank between flushes and can cause the interior to change into a dingy color. Faulty toilet components, like an old flapper, corroded tank lever or chain, or damaged seals, can also lead to dirty water as the materials break down inside the tank. You can clean the toilet tank or change out the old parts to give it a fresh start.

Silicone-based caulk is known for its waterproofing qualities, so it’s the best option for any bathroom area. While it’s often more expensive, it will provide a better, longer-lasting seal than acrylic or latex caulk. Use it along the base of the toilet to prevent leaks and keep the area clean and protected.