Top-rated toilet pros.

Best toilet pros near Thompson Falls, MT

Enter your zip and get matched with up to 5 pros

Need a pro for your toilet service project in Thompson Falls, MT?

Select your specific project to find the pro for you.

Top-Rated Toilet pros in Thompson Falls - Updated Nov 2026

Northwest Montana Plumbing Services
5.0(
3
)
Faucets, Fixtures and Pipes - Repair or Replace

Serving Thompson Falls, MT and surrounding areas

In business since 2012

Free estimates

Warranties offered

\nWe started Northwest Montana Plumbing Services with a simple goal: to offer top-quality plumbing, heating, and air conditioning solutions for homes and businesses. With a focus on reliability and professionalism, we proudly serve the entire Northwest Montana region from our base in Libby, MT. \nAFTERHOURS SERVICE PROVIDED \nhttps://www.northwestmontanaplumbingservices.com/

Response time5 hrs
Recommended by100%of homeowners
AtWork4You
4.5(
2
)
Drain Clog or Blockage - ClearFaucets, Fixtures and Pipes - Repair or ReplaceFaucets, Fixtures and Pipes - Repair or Replace - For Business

Serving Thompson Falls, MT and surrounding areas

In business since 2010

Free estimates

Emergency services offered

We can help with general repairs, maintenance and upgrade to your home, be it outside tree trimming or your cellphone repair. We provide meticulous, honest and reliable service. We are well versed in all aspects of construction. Over 9 years of experience.

Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+25

Recommended by100%of homeowners
Avatar for TCH Builders & Remodeling
TCH Builders & Remodeling
4.0(
2
)
Faucets, Fixtures and Pipes - Repair or ReplaceFaucets, Fixtures and Pipes - Repair or Replace - For Business

Serving Thompson Falls, MT and surrounding areas

In business since 1999

Emergency services offered

Credit card accepted

If you dream it, we can build it. What's the biggest difference between us and them? We build to last! We offer a full line of Green and Energy Star Certified products, backed by our labor and manufacturer's lifetime transferable warranties. Credit Cards Welcome Financing Available OAC.

Recommended by100%of homeowners
Toilets FAQs, answered by experts

Yes, you can pour water down the toilet to help it flush. For each flush, you’ll need 1 to 2 gallons of water for newer toilets or 3 to 5 gallons of water for older toilets. Rather than dumping the entire bucket in all at once, pour the water in slowly for the best results. If you’re pouring water down the toilet to help it flush after a clog, only use 1 gallon of hot water.

After flushing the toilet, you should have about half a tank full of water. While the exact amount of water you’ll have will vary, you want to make sure you have enough to cover the bottom of the bowl and enough to sit above the P-trap drain. While low water in your toilet bowl can indicate a problem, too much water can also be cause for concern.

Yes, a toilet, sink, and shower can share the same vent. This is a common installation method that can simplify plumbing and save space. However, there are important considerations. The vent and associated plumbing must be large enough to handle the demands of all fixtures without compromising the vent's effectiveness. Additionally, the toilet should always be located downstream of all other fixtures. Because requirements can vary and space might be limited, it is essential to check your local building and plumbing codes and consult with a qualified plumber to ensure the installation is done correctly.

Yes, you should screw your flange to the subfloor, including cement. The best way to get this done is to predrill holes into the concrete using a hammer drill and a ¼-inch concrete bit. Be careful when you’re ready to bolt your flange down, as you can accidentally crack it. You can avoid this issue by not installing the screws too deep. Or, you can opt for a flange with a stainless steel ring so you don’t have to worry about cracking the plastic.

You can tell if your toilet fill valve is full by removing the lid and taking a look. When you flush the toilet, the float is at the bottom of the tank, the water empties, and the fill valve opens. The float rises to the top as the tank fills again with water. When the float rises to the right level, the fill valve closes; if the valve is too high, your toilet may only partially flush, requiring you to adjust the float. 

The Thompson Falls, MT homeowners’ guide to toilet services

From average costs to expert advice, get all the answers you need to get your job done.