Get matched with top bathtub restoration pros in Molt, MT

Refinishing a bathtub takes about two to four hours, but let the surface set for another 24 to 48 hours before using it again. Once it's set, your tub should last for 10 years or more. Ventilating the bathroom during this time is key for safety. In comparison, it takes about four hours to install a new bathtub.

Even at the lowest setting, there’s always a risk that pressure washing might damage your shower or tub. Never use this technique if there’s pre-existing damage in your shower or tub, like peeling caulk, sealant, or cracked tiles. And skip this method entirely if there are any wood features present.

Epoxy helps protect your garage floor from moisture, staining, and cracks over time. Concrete itself is typically porous, and epoxy fills those tiny holes and creates a smooth finish. Installing garage floor epoxy may also extend the life span of your garage to upwards of 20 years, as it strengthens the concrete and helps prevent water from seeping through it.

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.