Get matched with top bathtub restoration pros in Absarokee, MT

Even at the lowest setting, there’s always a risk that pressure washing might damage your shower or tub. Never use this technique if there’s pre-existing damage in your shower or tub, like peeling caulk, sealant, or cracked tiles. And skip this method entirely if there are any wood features present.

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

Reglazing a bathtub can last as few as three years and up to 15 years. With proper application, the recoated surface is as durable as a brand-new tub. Clean your tub properly and avoid using abrasive cleaners to maintain the coating. If the weather conditions were cold or humid during resurfacing or the tub was significantly damaged, the reglazing may not last as long.

Bathtub refinishing refers to the entire process of resurfacing a bathtub. Reglazing is one step in the bathtub refinishing process. To refinish a bathtub, a refinishing professional will clean the tub, protect the surrounding areas, remove the existing glaze, sand and prepare the surface, apply the new glaze coating, caulk the tub, and replace the fixtures.