Get matched with top bathtub restoration pros in Shepherd, MT

Bathtub refinishing refers to the entire process of resurfacing a bathtub. Reglazing is one step in the bathtub refinishing process. To refinish a bathtub, a refinishing professional will clean the tub, protect the surrounding areas, remove the existing glaze, sand and prepare the surface, apply the new glaze coating, caulk the tub, and replace the fixtures.

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

Epoxy helps protect your garage floor from moisture, staining, and cracks over time. Concrete itself is typically porous, and epoxy fills those tiny holes and creates a smooth finish. Installing garage floor epoxy may also extend the life span of your garage to upwards of 20 years, as it strengthens the concrete and helps prevent water from seeping through it.

If your Corian® countertop begins to appear dull or dirty, or you notice scratches on the surface, you can return it to its original finish while maintaining its look. To do this, repair any scratches with a repair compound and sand the surface after it dries. 

Then, use an orbital sander with either a 100-, 30-, or 15-micron disc and finish with a hand pad (like Scotch-Brite™ 7447 or 7448) or lamb’s wool bonnet and automotive cutting compound for a matte, semi-gloss, or gloss-finish, respectively.