Get matched with top deck maintenance specialists in Southaven, MS

In most cases, there should be a small gap between the house and the deck, usually no more than ½ to ¾ of an inch. This space allows water and moisture to flow through instead of pooling against the side of your house. It also lets flashing protect your siding from runoff, which is one of the most common issues with decks.

Building codes for deck railings can vary by location, so it's important to consult your local regulations before construction. Generally, a guardrail is required for any deck that is more than 30 inches above the ground.

For residential properties, the standard minimum height for a deck railing is 36 inches. However, some states and municipalities have stricter requirements; for example, California and Washington mandate railings that are at least 42 inches high. Therefore, a 42-inch railing is not considered too high and may be required in your area or chosen voluntarily for additional safety.

In addition to height requirements, codes also specify other safety features, such as the maximum spacing between balusters to ensure they are close enough to prevent a child from squeezing through.

While the terms deck and porch are often used interchangeably, they are two distinct structures. A porch is a covered structure, usually attached to the front of a home, that offers protection from the elements. In contrast, a deck is an open, uncovered platform, often attached to the back or side of a home. Because porches have a roof, they typically require less maintenance than decks, but both features need regular cleaning and repairs to stay in good condition.

Any wood deck provides some ventilation to the area below, as is the nature of that type of deck design. However, areas that experience excessive humidity and associated moisture benefit greatly from a dedicated ventilation system in the form of strip vents. This addition helps the various wood boards contract and expand evenly throughout the years and reduces the chances of twisting, warping, and buckling.