Get matched with top fencing pros in Magee, MS

You can DIY a stockade fence installation, but prepare to put in some good sweat equity. For the best results, carefully plan the exact location of your fence before you break ground. In particular, carefully map out your post locations before setting them in concrete. Be sure to call your local utility company before digging to avoid damaging underground wiring and causing severe injury.

On the other hand, installing stockade fencing on your own might sound too overwhelming. It’s certainly time-consuming and labor-intensive. Besides the hard work, you must install it properly to avoid gaps. Unless you’re confident you can get the job done right, hiring a privacy fence installer near you is the way to go.

Whether you need a permit to build or install a fence depends on several factors, including your location, the fence's height, its placement in your yard, and the materials used. In many cities and highly populated areas, a permit is required, especially for fences taller than 6 feet. Conversely, rural areas may have fewer restrictions. Typically, backyard privacy fences 6 feet or shorter do not require a permit, while front yard fences often have a lower height limit, sometimes as low as 3.5 feet. There can also be exceptions for properties in mixed residential-commercial zones. It's best to check with your local building inspection or zoning department to understand the specific requirements, height restrictions, and location rules for your area. A professional fence installer can help you navigate this process and often secure the necessary permits for you, though this may extend the project timeline.

When your rolls of silt fence join together, you’ll want to overlap them to make sure they’re still as effective at keeping water out without requiring fastening together. Overlap two sections of the silt fencing so that two sheets of fabric cover the span of two posts. If you want to fasten them together, you can staple them or use a zip tie, depending on whether your posts are metal or wood. 

You can sometimes install a fence over a gas line. Fence installation typically requires a two-foot depth for posts, so if the lines are shallower than two feet, you cannot put a fence post over the line. You’ll need to call 811 to get the gas lines located and marked before you start the project.