Top-rated epoxy flooring pros.

Get matched with top epoxy flooring pros in Monett, MO

Enter your zip and get matched with up to 5 pros

Need a pro for your epoxy flooring service project in Monett, MO?

Select your specific project to find the pro for you.

Find Epoxy flooring pros in Monett

Avatar for Flow Form Coatings, LLC
Flow Form Coatings, LLC
5.0(
6
)
Concrete Finishing, Overlays & Coloring - ApplyConcrete Floor Coating-ApplyConcrete Floor Coating-Apply - For Business

Serving Monett, MO and surrounding areas

In business since 2025

Free estimates

Warranties offered

"The quality of the workmanship is top notch. What stood out was their attention to detail and commitment to customer satisfaction. They showed up on time, kept the area clean, and explained the whole process in detail. It’s clear they take pride in their work and now I take pride in my garage."
Flake Style Flooring
The Shop - 30x60
Marble Galore!
Glass Like Finish!
Response time3 days
The Painting Company
4.7(
77
)
Concrete Floor Coating-ApplyConcrete Floor Coating-Apply - For Business

Serving Monett, MO and surrounding areas

In business since 1976

Free estimates

Emergency services offered

"Very neat and professional job.  This was a large job estimated at 2 weeks - essentially the whole 2nd floor of the residence.
Started by taping and covering floor with resin paper, then cloths on top of that.  Everywhere - including closets.
- We went with smooth walls vs. orange peel and Dave's team did a great job of preparing and finishing the plaster & lath walls prior to prime/paint.  They took the time to do it correctly rather than "patch" it.  Large open stairwell had wallpaper that was removed before prep and painting.  They corrected imperfections in closets as well - even cuttting and installing a piece of drywall to the ceiling of one where some of the plaster was too loose to safely repair.
- Ceilings were patched before paint, but having older sand texture paint, were not able to be smoothed as well as walls.
- All baseboard, door & window trim was sanded and primed with all old caulk and built up paint removed at joints.  Most imperfections from older paint was removed before priming over the old latex and covering with oil based.  Same level of detail with the original 5 panel doors. 
Again, this was a large job on an old home.  Compliments to Dave, Lynn and their team.  They were organized, hard working and very polite.  They have the equipment needed to do the job and cleaned up every night before leaving.  The work is professional and will last.
"
Recommended by95%of homeowners
Showing 1-10 of 34
Epoxy Flooring questions, answered by experts

Yes, you can seal old concrete, but proper preparation is essential. Before sealing, ensure the concrete is clean, dry, and free of any old sealant. To check if resealing is necessary, place a few drops of water on the surface; if they are absorbed in less than five minutes, it's time to reseal. If you are using the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are applying a different type of sealer, the existing one must be removed. Additionally, repair or fill any cracks to create a smooth base before you begin sealing.

Concrete floors are durable, low-maintenance, and customizable with various finishes and colors.

Acid-based concrete stain is generally considered the best option because it lasts about four times as long and penetrates the deepest into concrete to give richer, full-bodied colors. If you prefer more vibrant colors, though, many water-based concrete stains are available that could provide a solution you can't find from earth-toned acid-based solutions.

Outdoor kitchens get wet and are sometimes next to pools. To avoid accidents, go with a non-slip material like concrete, brick, or rubber. Avoid materials like ceramic and porcelain, as they are known to be quite slippery. Wood and composite flooring can be slippery if untreated, so make sure to stain or finish these materials.

Mix the resurfacer into a sticky mixture. The consistency should look like mashed potatoes. Use a squeegee to push the resurfacer across the pitted area and smoothen the surface with a cement trowel flush. Make sure you protect any expansion joints with a weather strip. Alternatively, cut out any resurfacer that touched the joint once the mixture begins to harden.

The Monett, MO homeowners’ guide to epoxy flooring services

From average costs to expert advice, get all the answers you need to get your job done.