Get matched with top concrete driveway pros in Independence, MO

The ideal PSI (pounds per square inch) for a pressure washer depends on the surface you are cleaning. For general home use, a pressure washer with a range of 2,000 to 3,000 PSI is recommended and powerful enough for most residential projects.

The specific PSI you should use varies by task:

• High-Pressure Tasks (2,500-3,000 PSI): Tough materials like concrete, stone, masonry, and brick can handle higher pressures. This is suitable for removing stubborn stains from driveways or cleaning graffiti.

• Low-Pressure Tasks (around 600-1,300 PSI): Softer surfaces require a gentler touch to avoid damage. Use a low PSI setting for cleaning wood decks (especially softwoods like pine and cedar), vinyl siding, outdoor furniture, and stucco.

For best results, choose the right nozzle for your surface, such as a 15-degree nozzle for siding or a surface cleaner attachment for driveways. Using an extendable wand can also make the work easier and more ergonomic.

Pressure washers are better for residential use. Power washers are best suited for cleaning very hard surfaces (like concrete and cement) and removing tough stains or tacked-on grime. Meanwhile, pressure washers have more uses. For example, you can use one to deep clean a wooden fence, spray down your vinyl siding, or clear out your gutters.

The best driveway cleaner for oil stains depends on the type of surface and the severity of the stain. An absorbent abrasive like baking soda works for many circumstances. By following up the baking soda with a white vinegar rinse, you can increase the effectiveness and ideally remove the stain for good. Concrete oil stains may respond better to oil stain removers designed specifically for concrete if the stain is tough to remove with at-home ingredients.

Some homeowners have luck using pressure washers, but this only works for old or weaker concrete sealants and with very powerful pressure washers. You’ll get better results by pressure washing water-based sealants. However, it’s worth trying on any sealant if you’re hoping for the least toxic, least expensive, and most DIY-friendly option. To try this method, rent or buy the most powerful pressure washer you can find and take several passes at the concrete, completely pressure washing the entire area. You may need to repeat the process multiple times to see results.