Get matched with top concrete driveway pros in Lees Summit, MO

If your epoxy application ended up a bit messy and left spills behind, there are several ways to clean epoxy off of a concrete floor. You can use a power washer with at least 3,000 PSI. However, it may be easier to use a scraping tool or an acidic cleaner, like vinegar, to remove unwanted epoxy. 

If the entire floor has epoxy and you want to remove just excess epoxy stains, these methods could still strip parts of the epoxy floor. Move carefully and in small areas to minimize damage, or call a pro for an expert finish.

Whether you need to winterize your pressure washer depends on where you store it. If you can keep it in a relatively warm place with no risk of freezing, you won't need to add antifreeze. However, if the machine will be stored in freezing temperatures, any liquid left in the water pump can freeze, expand, and cause severe damage. To prevent this, add antifreeze to keep it in good condition. While some suggest emptying the machine with compressed air, this can be a tedious process that may not fully drain the liquid. Regardless of storage conditions, it is also good practice to empty the gas chamber and refresh the oil before winter storage.

Yes, pressure washers can remove rust stains from concrete. However, when coupled with an acid treatment, they can be even more effective. Just be sure to use a minimum of a 15-degree nozzle to prevent damage to the surface, and users must also be careful not to get in the way of the pressure washer’s jet as they can cut through skin and cause injury. 

The best plan for removing rust stains from concrete is to progressively move from weaker cleaners to heavy-duty acids. Move from dish soap to vinegar to oxalic acid to muriatic acid, stopping whenever the stain is sufficiently removed. This process ensures that only the safest possible methods are used, rather than jumping right into a powerful cleaner that may be effective but unsafe and unnecessary