Top-rated asphalt driveway pros.

Get matched with top asphalt driveway pros in Ellington, MO

Enter your zip and get matched with up to 5 pros

Need a pro for your asphalt driveway service project in Ellington, MO?

Select your specific project to find the pro for you.

Find Asphalt driveway pros in Ellington

TNT Turnover Services
New to Angi
Brick and Stone Driveways & Floors - InstallConcrete Driveways - InstallInterlocking Pavers for Driveways & Floors - Install

Serving Ellington, MO and surrounding areas

Approved

TNT Turnover Services isn’t just remodeling spaces—we’re transforming them.\n\nWe take outdated, worn, or underperforming areas and turn them into clean, modern, high-impact spaces built to impress and made to last. From kitchens and bathrooms to full property turnovers, our work is driven by precision, quality craftsmanship, and attention to every detail.\n\nAt TNT Turnover Services, we don’t believe in shortcuts—we believe in results. We bring reliability, speed, and professionalism to every project, delivering a smooth, hassle-free experience from start to finish. On time. On budget. Done right.\n\nWhether you’re upgrading your home or preparing a property for its next chapter, we’re here to raise the standard and exceed expectations.

Avatar for Mays Excavating
Mays Excavating
5.0(
3
)
Gravel or Loose Fill Paving - Install, Spread or Scrape

Serving Ellington, MO and surrounding areas

In business since 2023

Free estimates

"Ben and his team were top-notch. They went above and beyond the scope of the project, removing heavy brush and clearing a road to grade with the correct slope for water runoff. I will hire them again."
Equipment
Befor/After
Before/After
Before
After

+1

Response time11 hrs
Recommended by66%of homeowners
Showing 1-10 of 45
Asphalt Driveways questions, answered by experts

The dimensions of a driveway apron vary based on local building codes, the width of your driveway, and the distance between the driveway and the road. On average, aprons range from 12 to 24 feet wide and 8 to 18 feet long. Typically, the end of the apron connected to the driveway matches its width—such as 10 to 12 feet for a single-car driveway—while the end at the street flares out to allow cars to turn in and out more easily. In some areas, you may not be responsible for the portion of the apron that extends beyond the sidewalk, but this depends on local laws.

The answer to whether or not you need to get a permit before you start your driveway can vary widely based on local ordinances and the scope of your driveway ideas. In most urban and suburban areas, a permit is needed before building a new driveway to ensure that a homeowner is using safe materials and proper drainage practices while designing and constructing a new driveway. In some rural areas, a homeowner may not be required to apply for a permit. When building a new driveway on your own, always check with your local building department to see if you need to request a permit. When hiring a driveway contractor, verify that the right permits are being used before driveway construction begins.

Depending on project size, typically 1 to 3 days, including preparation and installation.

Driveway aprons typically range between four and seven inches thick, though your town's building codes will likely have specific requirements. Additionally, you may need to add a layer of permeable aggregate in the excavation below your paved apron to ensure proper stormwater drainage.

While some areas may allow for a slope of up to 20%, this is often the maximum slope for driveways, with a few exceptions of up to 25%. Other regions may have a maximum of 12%, 15%, or 18%, so check with your local building department to ensure you’re laying a driveway that is up to code for your location.

The Ellington, MO homeowners’ guide to asphalt driveway services

From average costs to expert advice, get all the answers you need to get your job done.