Get matched with top affordable plumbers in Bates City, MO

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

You can use other ways to seal the space where your tub and the bathroom tile meet. Using sealant tape, epoxy sealer, and spray foam can be just as effective as caulking your bathtub. When using alternatives to caulk, the one that is best for you depends on your preferences. 

Sealant tape takes less time and effort to use, which is why some homeowners prefer it. Meanwhile, epoxy sealer creates a smooth and glossy finish that can complement your bathroom. Lastly, spray foam is waterproof and can act as insulation for your tub.

First, check that you have cut off the water supply to your toilet. This is a project that can only be done safely if running water cannot reach your toilet fixture. If you're seeing water trickle out after you've confirmed that the water supply is shut off, you can probably rest assured that what you're seeing isn't a problem. It's common for leftover water to spill out when you're removing your toilet's fill valve. If something goes wrong while you're working on your toilet, you'll need to look at your home's policy to see if your homeowner insurance covers water damage.

The likely culprit is an air lock somewhere in your pipes. This is especially true if the warm water upstairs is accompanied by a decline in water flow. Other causes of this issue include frozen pipes, leaks, damaged supply lines, and more. There’s a simple DIY fix to try for air locks: Turn the hot water and cold water faucets on for a minute, then turn off the cold water and then the hot water. Repeat this process two or three times.