Top-rated concrete leveling pros.

Get matched with top concrete leveling pros in Willmar, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your concrete leveling project in Willmar, MN?

Select your specific project to find the pro for you.

Find Concrete leveling pros in Willmar

Avatar for Anderson Concrete Lifting
Anderson Concrete Lifting
5.0(
6
)

Serving Willmar, MN and surrounding areas

Approved

Free estimates

Emergency services offered

Warranties offered

"We were very pleased with the estimating process, quality of the work and the completion our project by Anderson Concrete Lifting. Throughout the process we were treated fairly and with respect. We highly recommend Joe and his crew for your concrete project."
Additional Photos
Response time2 days
1 neighbors recently requested a quote
Recommended by100%of homeowners
Avatar for American Waterworks
American Waterworks
4.6(
169
)

Serving Willmar, MN and surrounding areas

Approved

In business since 1989

Free estimates

Warranties offered

"They did great. The entire surface was level and free from tripping hazards. It is important to have them seal the cracks because there will be water from snow melt and the concrete will move. This will get you the 5 yr warrantee just in case."
Another Sinking Floor
Dirt Crawlspace in Elk Mound, WI
Concrete stoop had sunk over 6 inches
Foundation Failure Signs
Increased Efficiency of Crawlspace in Elk Mound

+156

Response time3 hrs
641 neighbors recently requested a quote
Recommended by92%of homeowners
Concrete Leveling questions, answered by experts

Polyjacking and mudjacking can both be effective solutions for sinking concrete, but they have key differences. Polyjacking, which uses expanding polyurethane foam, is often considered a better option because the foam is significantly lighter than the cementitious material used for mudjacking. This reduced weight puts less pressure on the underlying soil and lowers the risk of future sinking. Polyjacking is suitable for any sinking concrete slab, while mudjacking is typically only recommended for non-structural concrete, such as sidewalks, patios, pool decks, and driveways. The primary drawback of polyjacking is its cost, which can be up to four times higher than mudjacking—as much as $25 per square foot compared to a maximum of about $6 per square foot for mudjacking.

Mudjacking typically takes 24 to 72 hours (one to three days) to dry and cure completely before you can resume normal use. The total drying time can vary depending on the size of the project. Because the slurry mixture contains cement, it needs to harden fully to prevent the concrete slab from shifting under added weight. You should avoid walking on the concrete or placing heavy items like furniture or vehicles on the surface until it has fully set. Your concrete contractor can provide a precise timeline. As a point of comparison, if you opt for polyjacking, the polyurethane foam can dry in minutes, but it's recommended to wait about an hour before use.

Mudjacking is suitable for sidewalks, driveways, patios, and nearly all exterior flat structures. However, it may not suit severely damaged or heavily cracked areas.

It’s best not to perform mudjacking in the winter unless the ground temperature remains above freezing. Freezing temperatures can cause the slurry to harden too quickly, compromising its strength and longevity. Concrete is also more susceptible to cracking and splitting in cold temperatures, so there’s a higher risk of damaging the slab during the drilling and lifting process in winter.

Mudjacking restores level surfaces, prevents further damage, and is more cost-effective than a full replacement.

The Willmar, MN homeowners’ guide to concrete leveling services

From average costs to expert advice, get all the answers you need to get your job done.

What do you need done? We’ll find top pros.
  • 🌱 "Mow a small front yard"
  • 🛠 "Fix a leaking pipe under the sink"
  • 🏠 "Repair shingles on an asphalt roof"