The size of your home will help determine the size of your electrical panel. Usually, the decision comes down to a 100-amp electrical panel versus a 200-amp panel. Smaller homes, especially those without an HVAC system, may be able to get by with a 100-amp panel. 

If you have a larger home or need to power AC, a 200-amp panel should be the best fit. It’s unlikely that you’ll need a larger panel than that unless you have a larger home or unique electrical needs, but an electrician can help you make the final call.

No, wiring does not need to be redone to get a dimmer switch, as they work with single-pole and three-way switches. Just ensure you choose a dimmer that is compatible with your wiring, fixture, and lightbulbs. Most homes built after 1985 have neutral wiring and work with almost all dimmers. If your home was built before 1985 and you don’t have an updated electrical system, you may have to use a non-neutral wiring dimmer.

It can be safe to buy or live in a house with knob and tube (K&T) wiring, but only if the system is in good condition, functional, and has been thoroughly inspected and approved by a licensed electrician. Never purchase a home with K&T wiring without getting a professional electrical inspection first.

Key considerations include:

• Safety and Condition: An inspector will verify that the wiring is safe and has not deteriorated. Over time, the insulation can wear away, leaving exposed wires that pose a significant fire or shock hazard.

• System Capacity: The electrical service should be at least 60 amps. However, even at this capacity, K&T systems often struggle to handle the demands of modern appliances and electronics.

• Lack of Grounding: Knob and tube wiring is an ungrounded system, which is a safety concern for many modern devices.

• Ongoing Maintenance: If you live in a home with K&T wiring, it's recommended to have it inspected by an electrician every one to two years to ensure it remains in safe working order.

Ultimately, any inspection or modification of a knob and tube system should always be performed by a certified professional.

A 60W LED bulb is likely labeled as “60W replacement” on the package—that’s because it provides about the same light output as a 60W incandescent bulb. In reality, it likely uses less energy—usually 15 watts or less. If that’s the case, then it’s perfectly fine to put a 60W LED bulb in a 40W socket. Your best bet is to read the package carefully. It will tell you the LED bulb’s actual wattage, and as long as it’s lower than the fixture, the bulb will be safe to use.