Get matched with top electricians in Henning, MN

Black is the standard color for hot wires, which transfer electricity to your outlets and switches. Red wires are also hot wires. White (and sometimes gray) wires are considered neutral, delivering power back to the panel. Finally, green wires, which are sometimes bare copper, are ground wires, used to ground an electrical circuit and prevent electrocution.

Just as fluorescent lights are more efficient than incandescent lights, LED lights are more efficient to run than fluorescent lights. The specifics will vary from product to product, but LED lights are typically twice as efficient as equivalent fluorescent lights. A 13-watt CFL bulb can replace a 60-watt incandescent bulb, but a 6- to 8-watt LED bulb can offer the same amount of brightness. Fluorescent lights offer about 50 lumens per watt, while LEDs offer about 100 lumens per watt. LED light bulbs typically last two to three times as long as CFL bulbs, too. 

For a 200-amp underground service, you need a minimum of #2/0 American Wire Gauge (AWG) copper or #4/0 AWG aluminum or copper-clad wire. Don’t forget that, at minimum, you’ll need to use a 1 1/2-inch schedule 40 or 80 PVC conduit to successfully run a 200-amp underground service.

Yes, you can convert a gas water heater to an electric one, but it is a complex process. You will need to ensure there is adequate power for the new electric unit, as they require more power than gas models. The project also involves safely closing off the gas lines and ventilation, and some cities may require a permit for the conversion. The cost can range from $1,500 to $4,100, depending on the installation scope, plumbing and electrical work, and the water heater model. For an accurate quote, it's best to contact a local professional. Also, be aware that your monthly utility bills may increase after the conversion, as natural gas is typically cheaper than electricity.