Top-rated above ground pool installation pros.

Get matched with top above ground pool installation pros in Esko, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your above ground pool installation project in Esko, MN?

Select your specific project to find the pro for you.

Find Above ground pool installation pros in Esko

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Above Ground Swimming Pool or Accessories - Repair or Service

Serving Esko, MN and surrounding areas

In business since 1971

Credit card accepted

"One oven doesn't work at all ( my choice, see above), the "working" oven was never calibrated properly so using it is hit or miss. It's time to call American Home Shield to see about replacing the entire unit. I'm waiting to finish other home projects before calling them. I don't know if I'll request Greenway again."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Frank Haydon
2.8(
5
)
Above Ground Swimming Pool or Accessories - Repair or ServiceSwimming Pool - Above Ground, Build or Install - Have MaterialsSwimming Pool - Above Ground, Build or Install - Need Materials

Serving Esko, MN and surrounding areas

In business since 1991

Free estimates

Emergency services offered

"Frank was very knowledgeable. He did an excellent job with the pool, pricing was more than fair and he was always making sure I was happy with the way things were going throughout the entire process. I would recommend him again any day and I will be brining him back again when I add more upgrades to the pool room."
Recommended by100%of homeowners
Install Above Ground Pools questions, answered by experts

Yes, you should keep your pool pump running when adding salt, and leave it running for 24 to 48 hours. This will help circulate the salt to ensure even distribution. You will want to turn off your pool’s salt chlorine generator before adding salt and leave it off until it fully dissolves. Check your manufacturer’s instructions for steps specific to your saltwater pool maintenance.

The best way to kill off an algae bloom in an aboveground pool is to shock it with a large dose of chlorine. Shock typically kills off algae in about one to three days, although it can take longer if the pool water is in poor condition. After the shock treatment, add algaecide to prevent algae from growing back, and test the water every few days with test strips to ensure the pool’s pH doesn’t get out of whack.

If you've decided to fill in or remove your pool, begin by researching local, reputable pool removal companies to take care of the job for you. There are a variety of companies and contractors that can handle the work. You can start by looking for demolition or construction companies. Also, some pool builders will handle fills and removals.

It’s best to avoid having wrinkles in a new pool liner. Since pool liners are very thin, it’s easy to have slight wrinkles in the liner upon initial installation. This might negatively affect your pool’s visual appearance and lead to tearing and holes in some cases. You’ll want to ensure proper measurements and accurate alignment during the installation process to prevent unsightly wrinkles from appearing.

Yes, a pool with a heater will lose more water. The heater warms the water, which increases the rate of evaporation. To minimize water loss from evaporation, you can install a pool cover and keep the pool covered when it is not in use.

The Esko, MN homeowners’ guide to above ground pool installation services

From average costs to expert advice, get all the answers you need to get your job done.