Get matched with top pool table assembly pros in Dellwood, MN

Avoid the dreaded pool pop by only draining your pool during dry, temperate times of the year. If there is too much moisture or the threat of ice in the ground surrounding your pool, the pressure could disrupt the stability of your pool's floors and walls. Additionally, always open the hydrostatic drains in an inground pool toward the end of the design process.

You should add chlorine within 48 hours of filling your pool with water. In just 24 hours, bacteria and algae will begin to grow and contaminate your water. After that point, you’ll need to shock the water with high levels of chlorine, and you’ll likely need to do additional vacuuming to get the pool clean. It’s important to check your chlorine levels two to three times a week and add more chlorine as needed to maintain a healthy level.

Yes, pool pumps use a significant amount of electricity, making them one of the biggest energy consumers in a home. A pool pump can use up to three times as much electricity as a refrigerator. Typically, a residential pool pump consumes about 1 kilowatt-hour (kWh) for every hour it runs. Because pumps often need to run for about eight hours a day to properly filter the water, this can add up to an annual consumption of 3,000 to 5,000 kWh, which can cost between $480 and $800 per year based on average electricity rates.

The amount of electricity your pump uses depends on its size, energy efficiency, and daily run time. To lower your energy consumption, you can choose an energy-efficient or variable-speed pump, ensure it is correctly sized for your pool, and run it only for the minimum time required to keep the water clean.

Detecting a leak in your pool costs about $300 on average. The price ranges widely from low $100 up to $1,000. Here are the costs involved in leak detection services for your pool:

• Pool inspection: $125–$250

• Above ground pool leak detection: $100–$700

• Inground pool leak detection: $400–1,000

• Vinyl liner repair: $350–$3,600

• Fiberglass lining repair: $300–$400

• Concrete liner repair: $75 per linear foot

• Pressure test pool lines: $200–$500

• Skimmer repair: $100–$250

• Main drain repair: $400–$700

• Pump repair: $50–$300

• Tile repair: $20-$30 per linear foot