Top-rated radon detection and reduction specialists.

Get matched with top radon detection and reduction specialists in Atwater, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your radon detection and reduction project in Atwater, MN?

Select your specific project to find the pro for you.

Find Radon detection and reduction specialists in Atwater

Avatar for American Waterworks
American Waterworks
4.6(
170
)
Radon Gas - AbatementRadon Gas - Testing

Serving Atwater, MN and surrounding areas

Approved

In business since 1989

Free estimates

Warranties offered

"This job was completed efficiently and professionally. A design specialist came to test and measure every detail for the project. The crew arrived with everything needed for the job. They worked very hard to install Waterguard in the concrete floors inside around the foundation to the sump pump basket. They also installed Geo-lock anchors to support a block wall that was bowed. This company has 36 years in business and provides excellent results and professional customer relations. Call Amer. Wtrwrks for a free estimate. You will not be disappointed. A wise investment of $11,270."
Another Sinking Floor
Dirt Crawlspace in Elk Mound, WI
Concrete stoop had sunk over 6 inches
Foundation Failure Signs
Increased Efficiency of Crawlspace in Elk Mound

+156

Response time3 hrs
636 neighbors recently requested a quote
Recommended by92%of homeowners
Radon Detection and Reduction questions, answered by experts

Radon is a cancer-causing radioactive gas that poses serious health risks, infiltrating homes through foundation cracks and unnoticed spaces.

Radon enters your home when warm air begins to rise and exits through the roof, creating a vacuum that pulls cooler air from under the foundation. Part of that air is radon, which is an invisible, odorless gas that develops naturally when radioactive particles are deep within the ground. Those particles usually come from decaying matter in soil and rocks.

Testing every 2-5 years or upon adjusting occupancy or structural changes maintains safe environments.

No level of radon is technically safe, but since it is naturally present everywhere, it is impossible to avoid entirely. The average radon level in homes across the United States is 1.3 picocuries per liter (pCi/L). The Environmental Protection Agency (EPA) recommends taking action to reduce radon levels if your home's test results are between 2 and 4 pCi/L or higher.

You'll need to test your home for radon after installing the mitigation system, then again every two years. If radon remains elevated, contact a licensed radon professional, either the contractor who installed the system or a different one, and have them evaluate the system. They may need to make some changes to improve its effectiveness and performance.

The Atwater, MN homeowners’ guide to radon detection and reduction services

From average costs to expert advice, get all the answers you need to get your job done.