Top-rated epoxy flooring pros.

Get matched with top epoxy flooring pros in Sandusky, MI

Enter your zip and get matched with up to 5 pros

Need a pro for your epoxy flooring service project in Sandusky, MI?

Select your specific project to find the pro for you.

Find Epoxy flooring pros in Sandusky

Avatar for WELCH TILE & MARBLE
WELCH TILE & MARBLE
4.9(
11
)
Concrete Floor Coating-ApplyConcrete Floor Coating-Apply - For Business

Serving Sandusky, MI and surrounding areas

In business since 1987

Free estimates

Credit card accepted

"Brady came and gave me an estimate.  They were able to start the work the next day.  It went quite well.  They ran into a slight problem in that some of the sub floor came up with the tile.  But it did not result in much of a price increase.  The floor was extremely uneven, but after they were finished, it was even and ready for us to install our floating floor.  They did a great job.
"
Recommended by100%of homeowners
Showing 1-10 of 28
Epoxy Flooring questions, answered by experts

Yes, you can seal old concrete, but proper preparation is essential. Before sealing, ensure the concrete is clean, dry, and free of any old sealant. To check if resealing is necessary, place a few drops of water on the surface; if they are absorbed in less than five minutes, it's time to reseal. If you are using the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are applying a different type of sealer, the existing one must be removed. Additionally, repair or fill any cracks to create a smooth base before you begin sealing.

Yes. So-called “floating” cork floors can be installed over concrete subfloor, though a polyethylene vapor barrier is required. This type of installation is achieved using the glue-down tiles, which are trickier for a DIY approach, so consider calling a professional to help you if you’re planning to install your cork floor over concrete. 

If your concrete stains are green in color, it indicates the presence of mold or algae—which you should address right away. If left unattended, mold will spread to other areas throughout the home. However, be careful not to disturb mold on indoor concrete surfaces and work with a local mold remediation specialist for specialized care. Once free from mold and algae, seal your concrete to eliminate pores and gaps.

To prep a floor for painting, start by sweeping and cleaning any loose debris that could puncture the protective material. Take out as much furniture as possible. Then lay plastic, canvas, rosin paper, or masonite sheets across the room, securing them at the edges with masking tape. Plan your painting so that you minimize the chances you’ll step in and track any splatters.

No. You cannot use asphalt products on concrete driveways. To seal a concrete driveway, use acrylic, epoxy, polyurethane, silane, siloxane, and silicate sealers or deep penetration sealers made specifically for concrete. Meanwhile, asphalt sealers contain refined coal tar (asphalt emulsion), water, sand, clay, polymers, and additives and are incompatible with concrete’s surface texture and higher density.

The Sandusky, MI homeowners’ guide to epoxy flooring services

From average costs to expert advice, get all the answers you need to get your job done.