Best epoxy flooring pros near Caro, MI

Yes, you can seal old or existing concrete, but proper preparation is crucial. The concrete surface must be clean, dry, and free of any incompatible old sealant. To check if an old sealer is present, drip a few drops of water onto the surface; if the water is absorbed in under five minutes, it's ready to be resealed. If you plan to use the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are using a different type of sealer, the old one must be completely removed. Before applying the new sealer, thoroughly clean the concrete and repair or fill any cracks to ensure a smooth, well-prepared surface.

Concrete sealers will help your garage floors resist water, but they will not make the floor waterproof. You will need to purchase a specific waterproof floor paint for concrete and apply several coats over several days if you want your garage floor to be truly impermeable. While the process is similar to sealing the floors, the materials are different, and the need for multiple coats will extend the process and drying time.

Mix the resurfacer into a sticky mixture. The consistency should look like mashed potatoes. Use a squeegee to push the resurfacer across the pitted area and smoothen the surface with a cement trowel flush. Make sure you protect any expansion joints with a weather strip. Alternatively, cut out any resurfacer that touched the joint once the mixture begins to harden.

When you are laying hardwood flooring—or any other material that does not flex well with humidity—you will want to check the moisture level of your subfloor before proceeding. Flooring like luxury vinyl tile and bamboo performs better than more rigid materials in environments where moisture might be present. However, thorough testing is always an excellent preventative measure to control and monitor water in your home.