Top-rated electricians.

Get matched with top electricians in Rapid City, MI

Enter your zip and get matched with up to 5 pros

Need a pro for your electrical service project in Rapid City, MI?

Select your specific project to find the pro for you.

TRUSTED BY RAPID CITY, MI HOMEOWNERS

  • Average homeowner rating star icon4.7
    Average homeowner rating
  • Verified reviews icon85
    Verified electrical services reviews

Find Electricians in Rapid City

Avatar for Bay Electric of Northern Michigan, LLC
Bay Electric of Northern Michigan, LLC
5.0(
5
)
Electrical Switches, Outlets & Fixtures - Install or RepairElectrical Switches, Outlets & Fixtures - Install or Repair - For BusinessElectrical Wiring or Panel Upgrade+7 more

Serving Rapid City, MI and surrounding areas

Approved

In business since 2007

Free estimates

Emergency services offered

"I went on Home Advisor for help contacting an electrician. David from Bay Electric of Northern Michigan LLC contacted me about 2 hours later. David came to my house a couple days later, to go over what my needs were. My project was to upgrade my electric box from fuse panel to breaker box, upgrade electrical service from 60 amp to 100 amp, and install electrical service to a new pole barn. David gave me an estimate which I accepted. David did the whole job including permits, scheduling with Consumers Power, final inspection.etc. David also supplied wire, 2 breaker boxes, and everything needed. Very professional, friendly, and complete service. I highly recommend this company. The job was completed in 1 day. David is coming back in Feb. to connect my generator to whole house service for when power outages occur."
Electrical project
Electrical project
lighting
Electrical work
Electrical project

+22

Response time1 hour
1 neighbors recently requested a quote
Recommended by100%of homeowners
Showing 1-10 of 38
Electrical questions, answered by experts

A 60W LED bulb is likely labeled as “60W replacement” on the package—that’s because it provides about the same light output as a 60W incandescent bulb. In reality, it likely uses less energy—usually 15 watts or less. If that’s the case, then it’s perfectly fine to put a 60W LED bulb in a 40W socket. Your best bet is to read the package carefully. It will tell you the LED bulb’s actual wattage, and as long as it’s lower than the fixture, the bulb will be safe to use.

You can identify Federal Pacific Stab-Lok® breakers by the label on the front of the panel that says “Federal Pacific” or “FPE” and the breaker itself should say “Stab-Lok®” either on the face of the panel or a label inside the panel door. The Stab-Lok® breakers are also usually red on the breaker switch.

The hot wire is typically black, but it's essential to use a non-contact voltage tester to confirm the electrical wire color code before working on it. Neutral wires are typically white. It’s vital to determine which wire is carrying electrical current before proceeding with any electrical work.

If your microwave is on the fritz and you suspect the fuse has blown, you can check it to confirm it’s the source of the problem. Start by disassembling the panel and carefully checking the fuse filament or ceramic components. If your microwave uses a glass fuse, you’ll likely see discoloration and a melted filament. If your microwave contains a ceramic fuse, you’ll need to use a multimeter continuity tester to check if there’s continuity.

Often, you can add extra breakers to an electrical panel. A new breaker can help with new appliance needs, and it’s a common solution when finishing an attic or basement. However, adding extra breakers can’t bring in more amps to your house, so you still need enough amp service to power everything in total. 

The Rapid City, MI homeowners’ guide to electrical services

From average costs to expert advice, get all the answers you need to get your job done.