Get matched with top furniture refinishers in Lonaconing, MD

A cloudy film on top of a wooden surface usually means either the incorrect cleaner was used or there is polish buildup. You’ll need to start over again and remove the surface cleaner with a damp rag and some water and dish soap. Be careful not to leave the wood surface wet as this could cause water damage.

Telling the difference between high-quality wood furniture and lower-quality pieces is challenging, but there are a few sign that indicate whether your furniture is worth repairing:

• Push your fingernail into an inconspicuous section of the wood. If it doesn’t leave a dent, it’s likely hardwood and is well worth a repair.

• Unzip the bottom of couches to look for the structural components. If they’re made of wood rather than particle board, it’s likely worth refinishing.

• Ask a local furniture repair technician. A reputable professional will let you know if you’re better off replacing rather than refinishing your specific item.

The difference between resurfacing and refinishing is that refinishing only works on solid surfaces that are in good condition, whereas resurfacing will restore a cracked or worn surface to its original, blemish-free state. Refinishing will leave you with a smooth and glossy surface you can’t get from resurfacing alone. If that’s the look you’re going for, contact a local concrete finishing contractor to achieve it.

Yes. A good mixture to condition your leather is made from one tablespoon of natural baby soap, a splash of vinegar, and 2 cups of warm water. Mix these ingredients in a bowl and use a microfiber cloth to rub it into the leather in small circles. 

You can apply the same technique with a mixture of one part vinegar and two parts linseed oil. Once you’ve applied this to leather with a cloth, let it sit for 10 minutes before buffing with a small cloth.