Top-rated well and pump technicians.

Get matched with top well and pump technicians in Clinton, MD

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Clinton, MD?

Select your specific project to find the pro for you.

TRUSTED BY CLINTON, MD HOMEOWNERS

  • Average homeowner rating star icon4.7
    Average homeowner rating
  • Verified reviews icon91
    Verified well and pump services reviews

Find Well and pump technicians in Clinton

Avatar for Third Generation Ceramic Tile & Plumbing
Third Generation Ceramic Tile & Plumbing
4.7(
67
)
Well Pump - Install or Replace

Serving Clinton, MD and surrounding areas

Approved

In business since 1952

Free estimates

Emergency services offered

"Long - very long - but was done and we are 98% happy with the changes we had to do for the rebuild. Somethings just could not be done via insurance and the way some items where."
Kitchen Refrigerator
Kitchen Counter
Kitchen Sink
Shower After
Vanity After

+3

Response time1 day
12 neighbors recently requested a quote
Recommended by87%of homeowners
Avatar for Sila Heating, Cooling and Plumbing
Sila Heating, Cooling and Plumbing
4.6(
2,180
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Clinton, MD and surrounding areas

In business since 1989

Free estimates

Emergency services offered

"One unit was fine. The heat pump unit needs some new parts as it is 11 years old and sitsc in the roof under the southern sun and is just getting worn down. So Rob from Sila recommended the parts that need replacing. Very good company that I have used for that to perform these twice yearly checkups. Highly recommended."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+4

Recommended by91%of homeowners
Avatar for Drain Surgeon Plumbing & Heating
Drain Surgeon Plumbing & Heating
4.6(
1,773
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Clinton, MD and surrounding areas

In business since 2007

Emergency services offered

Credit card accepted

"Very pleased - arrived on time - quoted the above job - had to replaced faucet and 30 year + old sump pump, main shutoff - cleared drain for sink/disposal and fixed dish washer drain pipe etc. Jermaine had to get WSSC to come out and repair outside water feed, otherwise he would have completed in a few hours (had to wait for WSSC). Again very pleased and would highly recommend! Drain Surgeon Plumbing & Heating and Jermaine are on my speed dial for future plumbing needs."
Recommended by92%of homeowners
Avatar for 7247 plumbing
7247 plumbing
4.6(
19
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Clinton, MD and surrounding areas

In business since 2003

Free estimates

Emergency services offered

"When we returned from vacation, the sump pump had failed, causing a mess in our mechanical room. We obtained the services of 7247 through Angi, and the response was swift. Lee Williams arrived, immediately identified the problem, took measures to secure a new pump, and installed it late in the evening. We were so grateful that he completed the replacement the same night."
Additional Photos
Recommended by100%of homeowners
...
Showing 1-10 of 66
Wells and Pumps questions, answered by experts

A sprinkler pump may not turn on because of problems with the power supply or the circuit breaker. It can also stop working if the motor burns out. If it’s not a tripped breaker, a burned-out motor, or another issue with the power, it’s time to call in a sprinkler repair pro to take a closer look.

Here are some signs of a bad well pump that a pro should look at: 

  • If your well pump isn’t pumping water, you could have a leak or malfunctioning pump on your hands. 

  • If your water pump runs nonstop, there might be a leak or problem with the pressure tank, which can cause the pump to fail. 

  • Low water pressure can happen because of your pressure tank, low-water levels, or a wrong-sized pump. 

  • Dirt or sediment in your water can be a problem with a powerful pump, damaged pump filter, or the pump’s location.

Repairs typically take 2-4 hours. Complex issues may require additional time.

Most professionals recommend that a deep well pump shouldn’t run more than 10 hours consecutively before cycling off. Overworking the well pump beyond the recommended amount can prematurely wear out your pump and burn out the motor, which means replacing it more often than you otherwise should need to. Your well pump should also come with the manufacturer’s use and maintenance recommendations that are specific to the model.

The average three to four-bedroom home typically uses a well pump rated for 8 to 12 gallons per minute (GPM). To find the most accurate size for your specific needs, a common rule of thumb is to count the number of water fixtures and appliances in your home and aim for that number in GPM. This calculation allows for about one gallon of water per minute per fixture. Because estimating the correct size can be challenging, it's best to have a professional technician make the final determination. A professional can ensure your pump provides sufficient water for your home, especially during peak usage hours.

The Clinton, MD homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.