Top-rated insulation pros.

Get matched with top insulation pros in Arlington, MD

Enter your zip and get matched with up to 5 pros

Need a pro for your insulation service project in Arlington, MD?

Select your specific project to find the pro for you.

TRUSTED BY ARLINGTON, MD HOMEOWNERS

  • Average homeowner rating star icon4.2
    Average homeowner rating
  • Verified reviews icon153
    Verified insulation services reviews

Find Insulation pros in Arlington

Avatar for Koala Insulation of The Greater Baltimore Area
Koala Insulation of The Greater Baltimore Area
4.8(
13
)
Blown-In Insulation - Install or UpgradeBatt, Rolled or Reflective Insulation - Install or UpgradeInjection Insulation - Install+1 more

Serving Arlington, MD and surrounding areas

Approved

In business since 2023

Free estimates

Warranties offered

"We had insulation installed a week earlier by Koala. During the insulation, Jasper (insulator) suggested another area that we might consider installing blown-in insulation. We agreed and the second job was performed on Friday, the 24th. Jasper and Richard were on time, the insulation project was well done and they left the area very clean. Would use them again."
Insulation Projects
Spray Foam Insulation
Insulation Projects
Blow-in Rig
Truck

+9

Response time8 hrs
1 neighbors recently requested a quote
Recommended by83%of homeowners
Avatar for Atlas Home Energy Solutions
Atlas Home Energy Solutions
4.1(
34
)
Batt, Rolled or Reflective Insulation - Install or UpgradeBlown-In Insulation - Install or UpgradeSpray Foam Insulation - Install

Serving Arlington, MD and surrounding areas

Approved

In business since 2009

Free estimates

Credit card accepted

"I hired Atlas Home Energy Solutions to remove old insulation and replace it with the foam technique. However, I ran into numerous unexpected problems due to a slow leak from old pipes. It took awhile to sort out. Atlas Home Energy Solutions gave me lots of expert advice. They were willing to come out and review the situation. They were also willing to reschedule and wait until another contractor dealt with the water issue and its ensuing problems. They helped me make some difficult decisions before they could insulate the crawl space. When it was ready for them to come and insulate the area they bumped their schedule forward to get it done. This company did sterling work. Their expertise and professionalism were outstanding. They really know what they are doing and guided me through a more protracted process than originally envisioned. I would highly recommend them to anyone."
Visual Inspection of all Areas of your Home
Attic Insulation and Air Sealing
Infrared Camera Inspection
Attic Spray Foam
Blower Door Whole House Air Leakage Test

+11

Response time1 day
Recommended by87%of homeowners
Avatar for Xanvria LLC
Xanvria LLC
5.0(
2
)
Blown-In Insulation - Install or UpgradeBatt, Rolled or Reflective Insulation - Install or Upgrade

Serving Arlington, MD and surrounding areas

Approved

Free estimates

Credit card accepted

"We had Xanvria remove the old insulation in our attic, air seal the attic, and install new R-49 batts. They did a really good job, were professional, and explained what they were doing along the way. Everything came out clean and we?re very happy with the work. I would definitely recommend them."
before
after
Insulation
Insulation
2 neighbors recently requested a quote
Cameron Home Insulation
4.6(
40
)
Batt, Rolled or Reflective Insulation - Install or UpgradeBlown-In Insulation - Install or UpgradeInjection Insulation - Install+2 more

Serving Arlington, MD and surrounding areas

In business since 1907

Free estimates

Credit card accepted

"Debbie, the AC&R salesperson, was very knowledgeable and confident. They were the 2nd quote I got for work and came in even lower than I expected (which gave me pause as a low bid is a red flag). But true to her word, they did the work professionally (mostly...see below) and promptly. While I had another company do the energy audit for the Pepco rebate, AC&R took over the work, did the blown fiberglass one day and the spray foam the next.



For the blown fiberglass in the attics above our additions, they added spray foam (from a can) around any gaps per the contract and foam board baffles at the soffits. The installer noted that all our soffits were blocked and the batting insulation was too wide for the rafter channels, so he leveled it out as best he could to ensure an even coating of blown insulation. At the end, he sealed up the gaps between the attic and our to-be-finished upstairs (cape cod style, so all one room).



For the spray foam insulation, the team came in the next day, and I had to be out of the house due to fumes. I did come back around noon as they expected to be done well before then. They didn't know I came in and I went to the back of the house to watch TV on my work break. The one annoyance was during their cleanup, one of the installers came down into our kitchen and then saw me. He said he was looking for a vacuum cleaner to clean the stairs. I told him don't worry about the carpet as it was getting pulled up, but this was the one piece of unprofessionalism I noted above. Contractors should NEVER use the homeowner's property; they should bring their own tools, including vacuums!



While the spray foam can get very messy, they kept the splatter mostly contained to inside the crawlspace, not the finished flooring. However, I was surprised that they didn't tape off the outlet covers or light switched. since the particles are so small, we're going to have to replace the switches/receptacles at our cost. Also, there was a storm door screen that wasn't covered and now needs cleaned. Basically, I think they should have taken more care in covering the very few items we left upstairs and the outlets/switches.



They didn't spray around the window frames (large gaps where window weights used to be) because the open cell foam would expand too much. If I wasn't there, I think they would have just left, but it was clear in our contract discussions they needed to insulate those spaces too. They used a few cans of "Good Stuff" equivalent, but didn't fill in the gaps entirely. It did the job well enough, but it's a ding against them as I expected more preparation.



Lastly, I thought that AC&R would walk me through all the scheduling and final "test out" (for the Pepco rebate), but I had to contact them and schedule with someone different each time. They were always prompt, but I expect the experts to know to do this for/with me rather than expect me to know the process. I go through it once in a lifetime while they do it weekly.



While the end of the review sounds more negative than positive, I would definitely recommend AC&R out to others as they're priced right, they have been in business for over a century, and like any contractor, you just need to follow up to be sure everything is done to your satisfaction.
"
Recommended by100%of homeowners
Avatar for Home Energy Loss Professionals (HELP)
Home Energy Loss Professionals (HELP)
4.4(
73
)
Batt, Rolled or Reflective Insulation - Install or UpgradeBlown-In Insulation - Install or UpgradeInjection Insulation - Install+2 more

Serving Arlington, MD and surrounding areas

In business since 2004

Free estimates

Emergency services offered

"Bob the owner helped me through the whole process from having the audit done on my home and did the insulation work as well. His crew was also polite and hard working, they got the job done when they said they would and I’m so pleased with the results ! My home is the same temperature on every level and my energy bill is lower then it’s ever been. Thank you Bob and your team I will definitely be referring you to my friends and family."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+1

Recommended by87%of homeowners
Garda Premium Insulation LLC
5.0(
2
)
Blown-In Insulation - Install or UpgradeSpray Foam Insulation - Install

Serving Arlington, MD and surrounding areas

In business since 2006

Free estimates

Small jobs welcome

"Garda did an insulation job for me in a back addition of my house. A lot of companies I contacted were not interested due to some of the complication of the job. Garda jumped right in gave me reasonable quote and had the job done from first contact to finish in 10 days. They were available every time I called with questions and they provided updates all along the way. I would highly recommend Garda Premium Insulation LLC for any insulation work."
Blow In Insulation R-49
Open Cell Spray Foam Insulation Slopes
Closed Cell Spray Foam Slopes
Crawl Space
Response time10 hrs
Response rate100%
Recommended by50%of homeowners
...
Showing 1-10 of 60
Insulation questions, answered by experts

While a few icicles on your roof are standard, a large accumulation can be a sign of a bigger problem, such as poor insulation. This is particularly true if you are also dealing with ice dams. If you have numerous large icicles, it is recommended to have a roofing contractor diagnose potential insulation issues and create a plan to solve them.

Excluding carpet, strand-woven bamboo provides excellent underfoot heat. Laminate flooring is also good for insulation and preventing cold feet in the winter. Bamboo tends to work better in climates that have more consistent temperatures, while laminate does a better job at insulating floors in homes that experience more extreme temperature changes, such as the deciduous climates of the northeastern U.S.

Yes, you should add an insulative cover to outdoor water spigots in the winter for better protection against freezing. Make sure to use waterproof insulating material—something like a towel or old shirt can actually make the faucet more prone to freezing when the material soaks up rain or snow.

Most homeowners installing blown-in insulation as a one-off DIY project should simply rent a blower. They tend to be very heavy, and contractor-grade machines can cost $13,000 to $16,000.

On it own, aluminum siding has a relatively low insulation value (also called R-value); aluminum siding has an R-value of 0.61. However, you can purchase insulated aluminum siding to increase the R-value to between 2 and 5. You can also install additional insulation within your walls to help maintain temperatures within your home. On average, insulation costs $1,825 to install throughout the typical home.

The Arlington, MD homeowners’ guide to insulation services

From average costs to expert advice, get all the answers you need to get your job done.