Best epoxy flooring pros near Lafayette, LA

Sealing resurfaced concrete is not an absolute necessity. However, it is recommended, and in most cases, a high-quality concrete sealer can protect the surface from stains as well as water penetration, extending the life of the resurfacing material. Some sealers are formulated to protect pigments from fading due to UV exposure. Sealer tends to enhance the colors in decorative resurfacing applications, making them more vibrant and richer compared to the duller, more faded appearance of concrete colors without sealer.

Whether it's better to stain or paint concrete depends on your budget, desired aesthetic, and DIY skill level. Generally, staining is a more durable option because the stain soaks into the concrete's surface and won't wear away like a topical paint coating. Painting concrete can trap moisture underneath the paint layer, which may cause the concrete to deteriorate over time. However, concrete paint offers a wider variety of colors, is typically easier and less expensive to apply, and is effective at covering up existing stains or blemishes on the surface.

Epoxy coatings for garage floors offer a variety of finish and design options, including:

• Decorative colored flakes: $10 per 250-pound bag

• Metallic epoxy: $5–$12 per square foot

• Rock or stone epoxy: $100 per gallon

• Acrylic and poly-acrylic sealants: $0.85–$1.15 per square foot

• Polyurethane sealant: $0.95–$1.10 per square foot

• Polyurea sealant: $150 per gallon

Yes, you can seal old concrete, but proper preparation is essential. Before sealing, ensure the concrete is clean, dry, and free of any old sealant. To check if resealing is necessary, place a few drops of water on the surface; if they are absorbed in less than five minutes, it's time to reseal. If you are using the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are applying a different type of sealer, the existing one must be removed. Additionally, repair or fill any cracks to create a smooth base before you begin sealing.