Top-rated septic tank pros.

Get matched with top septic tank pros in Cameron, LA

Enter your zip and get matched with up to 5 pros

Need a pro for your septic tank service project in Cameron, LA?

Select your specific project to find the pro for you.

Find Septic tank pros in Cameron

Avatar for Choice Home Warranty
Choice Home Warranty
4.0(
5,678
)
Septic System - Install or ReplaceSeptic System - Install or Replace - For BusinessSeptic System - Repair+3 more

Serving Cameron, LA and surrounding areas

In business since 2008

Emergency services offered

Credit card accepted

"He was able to quickly diagnose that the water leak from the water heater was a result of a ruptured tank, resulting in the need to replace the entire water heater."
Recommended by81%of homeowners
Request Quote
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Septic System - Install or ReplaceSeptic System - Install or Replace - For BusinessSeptic System - Repair+3 more

Serving Cameron, LA and surrounding areas

In business since 1971

Credit card accepted

"I just pay $75 you never know who's going to come out. They do everything electrical. Just about everything is covered except the septic tank. I had an air conditioner replaced. It went great, all I had to do was pay for the freon. He didn't charge e more than what was needed."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Request Quote
Septic Tanks questions, answered by experts

For the most part, choosing between 30/50 psi and 40/60 psi is based on your water-pressure preference. However, it can also depend a little bit on your house—if you have older plumbing, a lower water pressure can be easier on the pipes (and a bit more gentle on your well pump). 

The lower 30/50 pressure is usually enough for a single-story home, but you may want 40/60 if you have multiple stories, as the extra pressure helps water flow smoothly up to the second floor.

If your well pump is running continuously (meaning without turning off or stopping), it's a sign that your well pump is starting to break down. The length of time your well pump should cycle is dependent on many factors, like the tank size, pressure setting, and even the amount of water in your well. Generally, your well pump should cycle, or go from running to not running every few minutes.

Adding a thin layer of dirt over a septic drain field is fine, especially if soil erosion has occurred. However, adding too much dirt can compact the soil, reducing the drain field’s ability to absorb and filter wastewater properly. Avoid using heavy clay soil, as it can prevent proper drainage. Instead, use a light layer of topsoil and plant grass to help with soil stability.

How deep your septic system needs to be into the ground depends on several factors. In extremely cold environments, the tank needs to rest below the maximum frost line, which can be up to six or eight feet deep. The standard burying depth for most systems is between a few inches and four feet below ground level. Depth can also depend on the slope of the landscaping and other property variables. 

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.

The Cameron, LA homeowners’ guide to septic tank services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles