Get matched with top water heater pros in Viola, IL

The time it takes to install or replace a water heater depends on the type of heater and the complexity of the job. A professional can typically replace a standard tank-style water heater in one to three hours. However, if the work area is tight, such as a small closet or crawl space, the job could take four to five hours. Replacing an existing tankless unit takes about two to three hours, while upgrading from a tank-style to a tankless water heater is more complex and can take four to six hours. The project will take longer if you are switching fuel sources, such as installing a gas heater which can add about an hour to the timeline, or if the unit needs to be relocated.

Several signs indicate your water heater may be failing or in need of replacement. Key indicators include:

• Age: A water heater older than ten years is approaching the end of its typical lifespan.

• Water Quality: If you notice rusty or discolored water from your hot water faucets, or a foul odor similar to rotten eggs or sulfur, it can signal internal corrosion.

• Unusual Noises: Banging, rumbling, or popping sounds from the tank often mean sediment has built up, causing the unit to overheat.

• Leaks: Any water pooling around the base of the tank or visible leaks are clear signs of failure.

• Performance Issues: A decline in performance, such as water not getting hot enough, taking longer to heat up, low water pressure, or decreased efficiency, suggests the unit is struggling.

• Visible Damage: Obvious rust and corrosion on the exterior of the tank can indicate a more serious internal problem.

While these signs often point to replacement, some issues may be fixable. It's best to consult a professional plumber to diagnose the problem before investing in a new unit.

Water expands when heated and also when freezing. When water is heated, it expands by around 4%. For a full water heater, this is one of the main reasons malfunctions occur—the hot water has nowhere else to go but out. Due to the constant expansion and reduction in volume, it’s recommended (required in most places) that an expansion tank be installed.

Yes, most municipalities have codes that require water heaters to have pans. A pan is necessary when a water heater or hot water storage tank is installed in an area where water leakage could cause damage, such as an attic, second floor, or finished basement. Tankless water heaters are not required to have a pan since there is no storage tank.