Top-rated contractors.

Best contractors near Scales Mound, IL

Enter your zip and get matched with up to 5 pros

Need a pro for your contractor service project in Scales Mound, IL?

Select your specific project to find the pro for you.

Top-Rated Contractors in Scales Mound - Updated Nov 2026

Avatar for Homemade Design
Homemade Design
3.7(
322
)
Major Home Repairs (General Contractor)

Serving Scales Mound, IL and surrounding areas

In business since 2006

Credit card accepted

"I never contacted the provider or used this service in anyway. I have to
write this review so that the request to write this review stops
popping up.
The rating is bogus as it is required to be able to submit.
"
Pennsylvania Master Bathroom
Boston Small Condo Kitchen
California Client Saves with HMD Designer Discounts
Recommended by54%of homeowners
Avatar for Jill Seidner Interior Design
Jill Seidner Interior Design
3.5(
89
)
Major Home Repairs (General Contractor)

Serving Scales Mound, IL and surrounding areas

In business since 2006

Credit card accepted

"Once I sent her all the measurements, it took her a little while to get the options back to me.  Overall, they're good designs.  However, they're very simplistic and give general ideas for space planning.  I was hoping to have a better idea for sizes of furniture for the space and some variations on staging.  
Jill was very responsive when I did have a question.  I'm not sure how helpful it is to have a virtual design done.  If we lived in similar cities, I'd probably use her again for help with additional designs.
"
Recommended by55%of homeowners
Avatar for Preferred Home Improvements
Preferred Home Improvements
4.7(
12
)
Major Home Repairs (General Contractor)

Serving Scales Mound, IL and surrounding areas

In business since 2010

Free estimates

Emergency services offered

"Dillon was a great guy and worked fast and efficient. My house is 50 plus years old and the duct work had never been cleaned. Post the work, the house even smelled better. I am in the middle of a complete remodel and living in the house. I had all 11 vent grilles removed -(saved Dillon a pile of time not having to remove and re-install) and I would have thought a discount would have been in order."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+30

Recommended by100%of homeowners
Showing 1-10 of 18
Unfinished Carpentry FAQs, answered by experts

The easiest way to tell if a wall is load bearing is to check if it’s an exterior wall or if it runs perpendicular to the joists above and below it (or parallel to beams). Exterior walls are almost always load-bearing, and walls that run under beams or parallel to them are also usually load-bearing. There are exceptions to these rules, and walls that don’t fit into these categories can still be load-bearing. If you’re unsure, hire a structural engineer to look at your home to assess whether or not the wall is structural.

To calculate the number of linear feet of baseboard you’ll need, measure the length of each wall of the room you’re installing them in as close to the floor as possible, rounding up to the next full linear foot. If it’s your first DIY molding job, having a few extra feet on hand for miscuts is a good idea.

It’s best to use two screws to secure deck boards into every joist. Securing the boards to every joist makes the deck more structurally sound, while using two screws on the outer sides of the boards can help prevent warping and cupping.

Yes, a one-story house can have a load-bearing wall. The load-bearing walls in a single-story home are usually the exterior walls. If the house has a basement with exposed walls, the arrangement of the beams can help indicate what walls are load-bearing.

Yes, walls on the top floor can be load-bearing if stacked on the floor’s foundation.

The Scales Mound, IL homeowners’ guide to contractor services

From average costs to expert advice, get all the answers you need to get your job done.