Top-rated contractors.

Get matched with top contractors in Bellevue, IA

Enter your zip and get matched with up to 5 pros

Need a pro for your contractor service project in Bellevue, IA?

Select your specific project to find the pro for you.

Find Contractors in Bellevue

Avatar for Homemade Design
Homemade Design
3.7(
322
)
Major Home Repairs (General Contractor)

Serving Bellevue, IA and surrounding areas

In business since 2006

Credit card accepted

"I never contacted the provider or used this service in anyway. I have to
write this review so that the request to write this review stops
popping up.
The rating is bogus as it is required to be able to submit.
"
Pennsylvania Master Bathroom
Boston Small Condo Kitchen
California Client Saves with HMD Designer Discounts
Recommended by54%of homeowners
Avatar for Jill Seidner Interior Design
Jill Seidner Interior Design
3.5(
89
)
Major Home Repairs (General Contractor)

Serving Bellevue, IA and surrounding areas

In business since 2006

Credit card accepted

"Once I sent her all the measurements, it took her a little while to get the options back to me.  Overall, they're good designs.  However, they're very simplistic and give general ideas for space planning.  I was hoping to have a better idea for sizes of furniture for the space and some variations on staging.  
Jill was very responsive when I did have a question.  I'm not sure how helpful it is to have a virtual design done.  If we lived in similar cities, I'd probably use her again for help with additional designs.
"
Recommended by55%of homeowners
Avatar for Preferred Home Improvements
Preferred Home Improvements
4.7(
12
)
Major Home Repairs (General Contractor)

Serving Bellevue, IA and surrounding areas

In business since 2010

Free estimates

Emergency services offered

"Dillon was a great guy and worked fast and efficient. My house is 50 plus years old and the duct work had never been cleaned. Post the work, the house even smelled better. I am in the middle of a complete remodel and living in the house. I had all 11 vent grilles removed -(saved Dillon a pile of time not having to remove and re-install) and I would have thought a discount would have been in order."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+30

Recommended by100%of homeowners
All In One
5.0(
4
)
Major Home Repairs (General Contractor)

Serving Bellevue, IA and surrounding areas

In business since 2011

Free estimates

Credit card accepted

"My first experience on Angie's List was to find a contractor to repair a leaking roof.  When I purchase my home the roof had been replaced within 2 years of purchasing.  Yet within a year water was leaking into my living room.  When other contractors came out they'd stand in the driveway and look up at the roof, then tell me all I needed were new gutters, which didn't help. All in one actually got up on the roof to investigate determining where my roof was leaking and fix it. With their estimate they provided proof on insurance and state contractor certification.  Before the roof work commenced,  rain was forecast All In One, covered the roof with tarps.  Once the work was completed they cleaned up the yard and driveway of all the old tiles, nails, and other debris.  Shortly after they completed there work, it rained again.  I held my breath but no water came dripping down from the ceiling.  In addition to the roof, since they were going to be up on the roof, I had them replace an old skylight.  No, the skylight wasn't the cause of the leak, I just took advantage of the opportunity to replace it.
"
Recommended by100%of homeowners
Showing 1-10 of 14
Unfinished Carpentry questions, answered by experts

If the bowing basement wall is less than 2 inches, steel or carbon fiber straps are the best solution. For bowing that is more than 2 inches, wall anchors are the most effective. A contractor can help you decide the best method of repair for your home's foundation and also address the root cause of the trouble.

Yes, you will need a jack for a rim joist replacement. To prevent sagging and facilitate the removal of load-bearing wood, you’ll need to relieve the pressure from this joint before beginning work. 

Due to hydraulics and other specialized equipment, a sill plate and rim joist replacement are not typically a DIY project. Hiring a professional structural engineer and experienced contractors is the best approach to replacing rotted sill plates and rim joists.

Joists do distribute their load to beams, but they don’t sit on top of the beams. Instead, home builders nail or screw the joists directly to the beams such that the end of the joist butts up against the edge of the beam. Beams can sit on other beams for support, but you’ll never see a joist sitting on top of a beam or another joist.

For a professional carpenter, installing a window seat can take anywhere from a few hours to a few days, depending on some aspects of the project. Aside from building the seat itself, if they have to remove any cabinets, shelves, or baseboards, that will add time to the project.

Installing a tongue-and-groove wall requires similar techniques to those associated with installing shiplap. However, because of the precision necessary to make each board fit perfectly and the increased material prices, the cost is higher than that of shiplap installations. Expect to spend between $2 and $6 more per square foot for tongue-and-groove walls versus shiplap ones.

The Bellevue, IA homeowners’ guide to contractor services

From average costs to expert advice, get all the answers you need to get your job done.