Top-rated septic tank pros.

Get matched with top septic tank pros in Georgetown, IL

Enter your zip and get matched with up to 5 pros

Need a pro for your septic tank service project in Georgetown, IL?

Select your specific project to find the pro for you.

Find Septic tank pros in Georgetown

Septic Tanks questions, answered by experts

Bladder and diaphragm well pressure tanks are usually pre-charged at the factory. Even so, it’s important to check the air pressure in the tank using a tire pressure gauge on the relief valve. The instruction manual usually calls for 28 psi. Use a hand pump to add more air or release some air from the tank to reach the desired number. Check the pressure periodically to see if you need to add more air to the tank.

Septic tank lids may or may not be buried in a yard. Most lids are buried at least 4 inches deep unless you have an aerobic septic system. Aerobic septic systems need frequent cleanings, about every four months, so it’s best to leave these lids aboveground for easier access. For buried lids, homeowners can use risers that make it easier to locate and access a buried septic tank lid.

The average lifespan of a deep well pump is between 15 and 25 years, after which you’ll have to replace it. Several factors can affect the lifespan of a well pump, such as the quality of the unit. Proper maintenance and repair can also help extend your well pump’s lifespan as well as keep adequate water flow and pressure throughout your home.

Signs that your well is dry include a decrease in water pressure, strange odors coming from faucets, cloudy, bubbly, or discolored water, and water that’s warmer than normal. Signs that your well pump is bad are similar, but you may also notice higher-than-average electric bills, strange clicking sounds, and faucets that spit or sputter.

How do you set your well’s pressure tank? All you need to do is first drain the tank of water and find the pressure switch. Remove the switch cover and adjust the switch with a wrench—clockwise to increase water pressure, and counter-clockwise to reduce it. Each complete turn of the nut on the switch should equal 2.5 psi. Once this is done, replace the switch cover. All that’s left is to adjust the pressure of the tank itself using an air compressor and a tire gauge to support the new setting.

The Georgetown, IL homeowners’ guide to septic tank services

From average costs to expert advice, get all the answers you need to get your job done.