Top-rated toilet pros.

Get matched with top toilet pros in Filer, ID

Enter your zip and get matched with up to 5 pros

Need a pro for your toilet service project in Filer, ID?

Select your specific project to find the pro for you.

TRUSTED BY FILER, ID HOMEOWNERS

  • Average homeowner rating star icon4.7
    Average homeowner rating
  • Verified reviews icon549
    Verified toilet services reviews

Find Toilet pros in Filer

Avatar for Part Time Appliance Repair LLC
Part Time Appliance Repair LLC
5.0(
8
)
Drain Clog or Blockage - Clear

Serving Filer, ID and surrounding areas

Approved

In business since 2021

Emergency services offered

Small jobs welcome

"Water filter was jammed. Took it apart got it working again. Dryer vent cleaned it out. Went above and beyond expected service. Maybe has long hair BUT HIS SKILLS are excellent. Knows what he is doing. Left the place immaculate."
Cold, wet, and muddy
I think it was about 4 or 5 feet down
Fun project to dig into in the winter
All done
Built an outhouse

+21

Response time1 day
Response rate89%
5 neighbors recently requested a quote
Avatar for Marathon Plumbing Co LLC
Marathon Plumbing Co LLC
5.0(
3
)
Drain Clog or Blockage - ClearFaucets, Fixtures and Pipes - Repair or Replace

Serving Filer, ID and surrounding areas

Approved

Free estimates

Credit card accepted

Offers commercial services

"Theron and Vince are some of the most reliable, efficient plumbers I know. They got me onto their schedule right away, showed up to give me an estimate looking very professional, and preformed excellent, clean work. I thought all plumbing companies were the same until I called Marathon Plumbing. I will be recommending Marathon to everyone I know from here on out. No one can beat their professionalism and honest work."
Marathon Plumbing Co
Avatar for Chaud Company Plumbing Services LLC
Chaud Company Plumbing Services LLC
4.7(
28
)
Drain Clog or Blockage - ClearFaucets, Fixtures and Pipes - Repair or ReplaceFaucets, Fixtures and Pipes - Repair or Replace - For Business

Serving Filer, ID and surrounding areas

In business since 1986

Credit card accepted

"Well. 1st plumber who looked at the system said shower valves needed to be replaced but that was a problem because there are no access panels. Chaub plummer advised valves were good quality and there was no need to replace. He replaced/installed new hardware and did a great job in a timely manner."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Recommended by96%of homeowners
Showing 1-10 of 26
Toilets questions, answered by experts

You should choose the type of toilet that meets your budget, fits properly in your space, and matches the rest of your decor. If you’ve never gone toilet shopping before, you might be surprised at how many options are available. Most homeowners choose a two-piece toilet, which is the industry standard, and a gravity flush system is the most common. However, dual-flush and low-flush toilets are becoming more prevalent as more people become conscious of water consumption.

Yes, a toilet, sink, and shower can share the same vent. This is a common plumbing practice that can simplify installation and save space. When sharing a vent, it's important that the toilet is located downstream from all other fixtures. You will also need to ensure the vent pipe is large enough to handle the demands of all connected fixtures without compromising its effectiveness. Because requirements can vary, you should always check your local building and plumbing codes. Consulting a qualified plumber is recommended to ensure the vent is properly sized, installed, and adheres to all local regulations.

Yes, you should screw your flange to the subfloor, including cement. The best way to get this done is to predrill holes into the concrete using a hammer drill and a ¼-inch concrete bit. Be careful when you’re ready to bolt your flange down, as you can accidentally crack it. You can avoid this issue by not installing the screws too deep. Or, you can opt for a flange with a stainless steel ring so you don’t have to worry about cracking the plastic.

If you have to hold the toilet handle (also called the toilet lever) down to flush, you probably have a chain problem. A chain that cannot fully lift the flapper will close too early and not clear the toilet bowl. Try adjusting the chain length so there’s about ½ inch of slack.   

The toilet should rest 10, 12, or 14 inches from the back wall. As for other clearances, 15 inches is the minimum distance from the flange to any side wall or nearby fixture, including the shower, tub, and sink. Modern codes also require at least 24 inches of clear space in front of the toilet.

The Filer, ID homeowners’ guide to toilet services

From average costs to expert advice, get all the answers you need to get your job done.