"Very prompt. Ryler Henderson even a little bit early and came prepared. He did have to run get a few supplies, but was back extremely fast and had my whole job done. Start to finish in less than two hours. Professional work is exactly what exact exactly what was required on our appraisal report. Very personable and good communication skills and conversations skills. I would highly recommend him!"
"The problem turned out to be a burned out small electric door switch. I believe the price was way too expensive for the service performed and the price of the door switch. What more can I say? It got done."
Romes Electric, we proudly serve Cassia County and the surrounding communities with dependable, high-quality electrical services. From small repairs to complete installations, we specialize in all aspects of electrical work and take pride in doing the job right the first time. We combine friendly service, expert workmanship, and attention to detail to ensure results you can trust.
"I just moved into an antique house and was nervous about all things electric. They in and were very professional and thorough. Walked me through everything and eased my worries. Would 10/10 recommend."
"I was having problems with the installation of a Rind camera door bell. I talked to ring and the recommended Hello Tech to help me finsh the installation. They contacted me and came to the house the very next day . The technician was extremely helpfull and installed a jump wire so my exixting door bell wound be compatable with the Ring system"
"It went well he took time to position the light and move it around to make sure that it provided me with good coverage for the work area I needed it in."
When wiring a switch, the power typically comes into the receptacle first. The neutral wire goes straight to the outlet, while the hot wire is split. You'll need a wire nut to splice the hot wire back to one of the receptacles, but you will also tie another wire into that same wire nut and run to the switch. That way, you can control the flow of electricity to that particular receptacle by turning the switch on and off.
To prevent a plug from overheating, always ensure that the electrical load connected to the plug does not exceed the plug's capacity. If the plug feels hot to the touch or emits a burning smell, immediately shut off the circuit breaker and unplug all devices from the hot outlet. Prevent electrical fires by avoiding using extension cords or adapters with the plug, as they can cause it to overheat due to increased resistance. Additionally, ensure that the plug is properly inserted into the outlet and that the outlet is not damaged or loose.
Call your utility company immediately. Do not go outside, even in your own yard, and keep pets indoors. Downed power lines pose a serious electrocution hazard. They can also cause large power surges that could damage your appliances, so it’s a good idea to shut down power to your home if possible. If your breakers trip, leave them off until the utility company finishes its repair work.
The doorbell installation cost depends on which and how many parts you need to replace. A new transformer is the least expensive replacement and falls between $20 and $35, plus the cost of hiring an electrician to install it, which can be between $150 and $250. Replacing your entire doorbell system can cost $250 to $400.
Yes, you can put a GFCI outlet in almost any electrical outlet location. As long as the outlet is wired correctly back to a circuit breaker, you can likely replace the existing outlet with a GFCI outlet.
The Bellevue, ID homeowners’ guide to electrical services
From average costs to expert advice, get all the answers you need to get your job done.
Before you hire a licensed electrical contractor, you should learn the cost to run electric from the road to your house so you can budget for the project.
Is it time to upgrade your electrical panel? For the sake of safety, find out sooner than later by exploring our top signs that it’s time for an upgrade.
