Get matched with top toilet pros in Jasper, GA

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

Completing a full standard bathroom remodel offers the best value, with an average return on investment (ROI) of 70%. However, you don't need a full remodel to make an impact. To maximize value, focus on key components like flooring, the tub and shower, vanity, and cabinets. High-value upgrades include installing a walk-in shower, resurfacing a tub, retiling, or expanding the shower. For more budget-friendly options that still increase value, consider repainting with a light, neutral color, or updating the mirror and light fixtures. It's also crucial to address any necessary repairs, such as leaks, mold, or cracked tiles, as buyers will notice these issues. Avoid flashy upgrades like bathtub jets or steam showers, which don't add as much value.

Yes, you should screw your flange to the subfloor, including cement. The best way to get this done is to predrill holes into the concrete using a hammer drill and a ¼-inch concrete bit. Be careful when you’re ready to bolt your flange down, as you can accidentally crack it. You can avoid this issue by not installing the screws too deep. Or, you can opt for a flange with a stainless steel ring so you don’t have to worry about cracking the plastic.

Usually it’s fine to leave a toilet clogged overnight, as long as it’s not close to overflowing. In some cases, the extra time may give the clog time to work itself out. For example, if it’s caused by an excess of toilet paper, letting it sit could result in the clog dissolving and you may be able to simply flush it away by the time you wake up. 

Only let it sit though if you have more than one toilet in the home.