Get matched with top concrete driveway pros in Murdock, FL

If your garage floor is heavily soiled or stained, then it’s a good idea to powerwash it with a concrete cleaner before sealing. This process will remove dirt and debris to help the new sealer bond to the concrete properly, and it will also improve the look of your sealed garage floor. After power washing your floor, make sure you let the concrete dry completely before applying sealant, usually for 24 to 48 hours.

The ideal PSI (pounds per square inch) for a pressure washer depends on the surface you are cleaning. For general home use, a pressure washer with a range of 2,000 to 3,000 PSI is recommended and powerful enough for most residential projects.

The specific PSI you should use varies by task:

• High-Pressure Tasks (2,500-3,000 PSI): Tough materials like concrete, stone, masonry, and brick can handle higher pressures. This is suitable for removing stubborn stains from driveways or cleaning graffiti.

• Low-Pressure Tasks (around 600-1,300 PSI): Softer surfaces require a gentler touch to avoid damage. Use a low PSI setting for cleaning wood decks (especially softwoods like pine and cedar), vinyl siding, outdoor furniture, and stucco.

For best results, choose the right nozzle for your surface, such as a 15-degree nozzle for siding or a surface cleaner attachment for driveways. Using an extendable wand can also make the work easier and more ergonomic.

Yes, you can use a mixture of 1 tablespoon of bleach and a gallon of warm water to clean stubborn stains from brick. Do not use bleach without diluting it in water. Undiluted bleach may cause discoloration. You can use either Oxygen bleach such as OxiClean or chlorine bleach. Always wear protective gloves and eye protection when handling bleach.

Maintaining a driveway depends on its material. For concrete and asphalt, it's best to clean the surface thoroughly twice a year with a stiff broom and a pressure washer to remove accumulated dirt and debris. Sealing the driveway is crucial to protect it from water damage and freeze-thaw cycles. Before applying a sealant, pressure wash the surface to remove any loose sealant, dirt, or stains, as sealing over them will trap them. Any cracks or expansion joints should be filled with a flexible polyurethane caulk or asphalt sealer. In colder climates, use sand instead of salt for de-icing. Sand helps melt snow and ice without accelerating the freeze-thaw process, which can cause cracks.