Get matched with top roofers in Clarcona, FL

In some cases, yes, you can put a second roof layer over architectural shingles, but it depends on your home’s structural stability and the local building codes where you live. Architectural shingles are thicker and heavier than standard asphalt shingles, so you may need structural reinforcement or a structural engineer’s inspection before proceeding. Additionally, some building departments don’t allow for two roof layers, regardless of the roof type. You should ask a professional if ripping the old roof off before installing the new one is the best option for you.

A chimney cap costs about $300 on average to install, with prices ranging from $75 to $1,000. The final cost depends on several factors, including the professional you hire, the accessibility of your chimney, the cap's material and size, whether any repairs are needed, and if it requires custom fabrication. Chimney caps are usually made from galvanized steel, stainless steel, or copper. Copper caps are the most expensive, followed by stainless steel and then galvanized steel. Excluding labor, average material costs are around $100 for galvanized steel, $250 for stainless steel, and $600 for copper. You may also face additional costs, such as hiring a chimney sweep to clean the chimney before the cap is installed.

Furring strips (also called wood stripping) are not always necessary for a metal roof installation, but they are highly recommended and may be required by local building codes or the roofing manufacturer's specifications. There are several key reasons to use them:

• Energy Efficiency: Furring strips, made of wood or metal, create an air gap between the metal panels and the roof deck. This acts as a thermal break, reducing heat transfer into your home and improving overall energy efficiency.

• Moisture and Condensation Control: The air gap allows for better airflow, which helps prevent moisture buildup and condensation under the metal panels.

• Structural Support: They provide a solid, even frame to which you can attach the metal roofing panels.

It is especially important to use furring strips when installing a metal roof over existing shingles. Without them, the roof surface can be uneven, and you will experience greater solar heat gain.

No, you can’t use your home’s square footage. You have to calculate your roof’s square footage, and then you may have to convert your square footage measurement to correspond with how the roofing material is measured. For instance, some roofing is sold in “squares,” which equals the total square footage of the roof divided by 100. Shingles are sold in bundles that may not correspond to the number of squares you need. Metal roofing is sold as sheets, so determine the amount of square feet each panel will cover and then divide the total square footage by the coverage area.