Get matched with top pool and spa technicians in Orange, CT

A hot tub cover's lifespan is typically between three and seven years, with an average of five to seven years for a well-maintained one. The quality of the cover is a major factor; lower-quality polyester or vinyl soft covers can tear easily with regular use.

To extend the life of your cover, proper maintenance is key. This includes:

• Keeping the cover clean, dry, and out of the sun. Use a soft cloth and mild dish soap for cleaning.

• Applying a vinyl protectant spray.

• Cleaning the underside with a chlorine spray.

• Using a cover lift to prevent damage from rough handling.

• Protecting it from harsh weather.

• Keeping children and pets off the cover.

Investing in a high-quality cover and checking for a warranty at the time of purchase can also contribute to its longevity.

Yes, you can use silicone or epoxy hot tub repair kits to repair cracks in a hot tub. Always read the manual to see what the manufacturer recommends before attempting to repair a hot tub.

Yes, hot tubs can use a significant amount of electricity, primarily to keep the water heated. A typical hot tub uses between 1,500 and 6,000 watts, and the pump can add another 1,500 watts. This usage can result in a monthly cost of around $20 to $30. The exact amount of electricity consumed depends on several factors, including the hot tub's age, size, heater voltage (120V vs. 240V), usage habits, and thermostat setting. Newer, energy-efficient models generally use less power than older ones. To reduce electricity costs, consider investing in an energy-efficient model, using a quality insulated cover with a thermal blanket, and keeping the filters clean.

To refill a hot tub after winter, start by opening up the tub and giving it a quick cleaning. If you use antifreeze, drain out the water then grab a hose and thoroughly clean the tub shell out, spraying water into each jet of the tub. 

Reconnect the hot tub and turn the power back on. When it’s time to fill the tub again, insert the hose into the filter well (if available). Avoid trapping too much air in the water lines, which can cause the pump to lock up when it starts again. Add the necessary chemicals and start the heating process. It will take some time—most of a full day—for the water to heat up again.