Get matched with top air duct cleaners in Georgetown, CT

"Amazing service. A+ would recommend"

"Fabulous job. Had another once. Hands down such a great job done by this young man"

"Issue with Bell Mechanical This past August of 2024 we had a heat pump system installed in the house by Bell Mechanical. Unfortunately, we have had nothing but issues since with the biggest being no heat multiple times and now again today we are without heat in the majority of our house. It is freezing outside, we have a toddler and within the past week this is the 2nd time we have no heat (4th time since the system was put in). Not only is this a life safety issue, but it also is heart breaking to have your toddler tell you they are freezing. Looking for advice on next steps. We have never sued anyone or threatened to sue but this may be the time as we have had nothing but issues since the beginning. From the start we made it very clear that everything needed to be done to code and permitted. We were doing a lot of major renovations at our house and everything was being done to code and permitted. John (the salesman) at Bell said that was not a problem. John also told us that the only additional cost we could potentially incur outside of what he quoted us for the system and its installation would be a $500 fee for the installation of the heat strip. We accepted this and moved forward. After Bell removed our central air system and installed the new carrier system we got his with additional work needed at the tune of over 2k. Needless to say we were not happy. John told us the electrician they use and that if we used that electrician there would be no delay but if we used ours that it would cause a delay. So, we went with what John said as he was the expert. John got the electrician to come down a little in price which we were grateful for. Fast forward to when the building inspector came out to close out the permits for the work Bell did and other work being done at the house, the inspector told my contractor that the heat pump was not done to code. We were told that the electrical for it was not done to code and he could not close out the permit. My husband talked to the electrician Bell gave us who informed us that Bell told him to “cut corners” which was part of getting the cost down slightly. Reminder, we NEVER said to do this, we made it clear that everything needed to be permitted and even paid the permit fees to Bell. Back and forth with Bell and the electrician got the electrician to fix his work at no additional cost but Bell still needed to fix the outside plug which was not to code. Giovanni at Bell agreed that Bell would fix this issue at no additional cost. It has been 3 months now and Bell has still not rectified this issue and Giovanni and John are both nonresponsive to our follow-ups. Bell has also had to come out 4 additional times because our system was not working and again today, we have no heat. Today will be the 5th time they have to come out for issues on a system that is 4 months old. This is not OK. We have given Bell ample time to rectify the issues. Clearly they did not do the install properly and there is also the possibility we have a faulty system. We have never sued someone or went to court but then again, we have never had such large and costly issues."

"It went GREAT!!!"

"At the beginning it seemed that Chimney USA would have the expertise to complete the work well. There were some waiting on parts, that wasn’t a big problem at the time because I wanted it done right. The estimate listed that they would remove the front stone work to be able to get to the steel box fire box for removal and install new steel firebox, then replace all the stone work. Neither one of these parts was done. The 4 metal vents weren’t removed and replaced, the ash door was not installed. There seemed to be a problem figuring out how to get the steel firebox manufactured and to have it installed. The steel firebox was needed so that the side heating vents in the fireplace would work to bring heat into the room. As time went on, there was no resolution to get the firebox and install it. Very frustrating. I finally made the decision to just build the firebox using firebrick. This was a mistake now because there is no exchange of heat for the room vents now. We agreed to have grey firebrick and they installed a grey “cement” (not a fire brick and wouldn’t stand up for the heat of a fire) brick and the installation wasn’t complete to seal off the firebox. The masons didn’t seem to know what they were doing. This would mean that smoke would fill the room. I texted, sent photos, and sent a video of the issues and Chimney USA decided to send their masons back out the next day to fix this problem. This time they didn’t have the grey firebrick, but only red firebrick. They removed the grey “concrete” bricks and installed the red firebricks. None of the workers spoke English which made communication difficult. They had to use a translation app on their phone to communicate with each other. The masons didn’t understand that the firebox had to be completely sealed off so smoke wouldn’t enter the room. Finally, that firebox was complete, but not what I was expecting. The ash door was never found to fit my opening and never installed. The rock face removal and steel firebox was never completed. Those costs were far more expensive than just building the brick firebox. Their cost for the custom stone removal and install of the face of my fireplace was estimated at $3,200 and the steel firebox with damper was estimated at $2,135. Total of $5,335. This was taken off Angi on what it should have cost just to do what they did which was to remove the steel firebox and build a brick firebox. “How Much Does Firebox Repair or Replacement Cost? [2024 Data] Normal range: $160 - $750 Firebox repair or replacement costs $455 on average, but it can cost between $160 and $750, depending on the project's scope and details.” Based on this I’m being charge almost $5,000 for work not complete. This should have been adjusted based on the work complete and the estimate scaled down to represent the job completed. They want me to pay the whole original estimate. I contacted Chimney USA to say that the bill needed to be updated with a lessor amount based on the final work, but they didn’t respond, except to keep sending me the same estimate bill to be paid in full."

"A first class operation!"

"It’s a scam false advertising no training of any kind. Horrible customer service!"

"I am very satisfied with the service provided. It was done quickly and efficiently."