Get matched with top sink repair pros in Lyons, CO

Yes. You can replace just the stopper portion with a universal sink stopper. All you need to do is open up the existing stopper and pull it up from the drain. You should be able to remove and replace the stopper with bare hands. If the existing stopper seems to be stuck, use a pair of pliers to remove it.

Pedestal sinks are bolted or screwed into the floor and the wall to prevent it from moving out of place. You may have to change or add to the bathroom flooring when installing a pedestal sink if the flooring was laid around the previous sink, not under it.

The best place for a kitchen sink drain is the middle of the sink. Most people prefer center drains because they allow for better water and waste drainage, and the center location limits splashing because water flows straight down the drain hole. If the sink drain is too close to the edge of the sink, water can collect and drain too slowly. It can also be easier to clean sinks when the drain is closer to the center since debris is easier to wash down and doesn’t collect along the sides as easily.

Yes, you can fit a vanity unit to an existing sink, especially if you plan to custom-build the vanity. With a prefabricated vanity, you’ll likely need to make a few adjustments. It depends on the type of sink, the size of the sink, and the existing plumbing. If you plan to retrofit a sink into a prefabricated vanity, make sure you take precise measurements and that your sink is compatible with the vanity you select. Prefabricated units have a precut sink hole, so you’ll need the size to match your sink.