Get matched with top bathtub restoration pros in Lone Pine, CA

Two alternatives to reglazing are installing a bathtub inlay or a bathtub liner. An inlay is a low-priced mat that adheres to the bottom of a bathtub or shower. It’s useful for sealing minor leaks and concealing damage on the bottom of a tub. On the other hand, a bathtub liner is essentially a protective casing that goes over the entire tub. They are usually custom-fit and cost more than reglazing yet don’t last as long.

The difference between resurfacing and refinishing is that refinishing only works on solid surfaces that are in good condition, whereas resurfacing will restore a cracked or worn surface to its original, blemish-free state. Refinishing will leave you with a smooth and glossy surface you can’t get from resurfacing alone. If that’s the look you’re going for, contact a local concrete finishing contractor to achieve it.

Refinishing a bathtub takes about two to four hours, but let the surface set for another 24 to 48 hours before using it again. Once it's set, your tub should last for 10 years or more. Ventilating the bathroom during this time is key for safety. In comparison, it takes about four hours to install a new bathtub.

Resurfacing a bathtub is less expensive than replacing one. Resurfacing a tub costs about $330 to $630, depending on the material, while replacing a tub costs an average of $4,150. But remember that resurfacing is a temporary solution for a worn-out tub, and you may need to refinish a tub every few years to keep it looking new.