Top-rated plumbers.

Get matched with top plumbers in Adelanto, CA

Enter your zip and get matched with up to 5 pros

Need a pro for your plumbing project in Adelanto, CA?

Select your specific project to find the pro for you.

TRUSTED BY ADELANTO, CA HOMEOWNERS

  • Average homeowner rating star icon4.7
    Average homeowner rating
  • Verified reviews icon546
    Verified plumbing services reviews

Find Plumbers in Adelanto

Avatar for Thompson Family Plumbing and Drain
Thompson Family Plumbing and Drain
5.0(
6
)
Faucets, Fixtures and Pipes - Repair or ReplaceDrain Clog or Blockage - ClearDrain Clog or Blockage - Clear - For Business+17 more

Serving Adelanto, CA and surrounding areas

Approved

In business since 2019

Emergency services offered

Warranties offered

Thompson Family Plumbing and Drain, is a family-owned and operated business that takes pride in honest, dependable service. We believe in doing the job right the first time, treating every customer with fairness, respect, and integrity. Our hands-on experience and knowledge of the trade allow us to provide quality workmanship you can trust. As a family business, we look out for our customers’ best interests and make their concerns our top priority, because when you invite us into your home, you become part of the Thompson family.

Septic Pumping
Let's Pump
Drain Camera
Drain Inspection
Blue Epoxy

+6

3 neighbors recently requested a quote
...
Showing 1-10 of 322
Plumbing questions, answered by experts

You can adjust the mixing valve on your shower if it uses a single handle to control both hot and cold water by removing the handle and adjusting the cap on the mixing valve. The cap fits over the valve handle and creates a low and high point for your handle to spin. Remove the cap and turn it to adjust how it mixes hot and cold water, and then replace the cap and reinstall the handle.

Yes, copper pipes freeze at temperatures of 20 degrees Fahrenheit or lower. In fact, copper pipes are more likely to freeze than other piping types since they conduct energy and lose heat quickly. They’re also more difficult to insulate, since insulation may make it difficult for heat to reach the pipes during sudden surges of cold weather.

Most faucets come with a rubber or plastic gasket that prevents leaks—but that’s not always the case. If your faucet doesn’t come with a gasket or it’s leaking, use a caulk gun to seal the gaps and prevent water damage.

After flushing the toilet, you should have about half a tank full of water. While the exact amount of water you’ll have will vary, you want to make sure you have enough to cover the bottom of the bowl and enough to sit above the P-trap drain. While low water in your toilet bowl can indicate a problem, too much water can also be cause for concern.

A sewage ejector pump is necessary if you have any plumbing fixtures, such as a bathroom, laundry room, or sink, located below the level of your home's main sewer line. Standard plumbing relies on gravity to drain wastewater and solid waste into the municipal sewer system or a septic tank. For fixtures below this level, like those in a basement, gravity cannot move the waste upward. The ejector pump provides the force needed to pump the sewage up to the main line. Without one, wastewater from below-ground fixtures would back up, potentially causing a sewage overflow and flooding. If all of your plumbing is on the main floor or higher, gravity is sufficient and an ejector pump is not needed.

The Adelanto, CA homeowners’ guide to plumbing services

From average costs to expert advice, get all the answers you need to get your job done.